Pump Specifications - Paco-Pumps PIP702B Series Installation, Operation And Maintenance Instructions

PUMP SPECIFICATIONS:

DISCHARGE ....................... 2" NPT, Female, Vertical
LIQUID TEMPERATURE .... 77°F (25°C) Continuous
VOLUTE .............................. Cast Iron ASTM A-48, Class 30
MOTOR HOUSING ............. Cast Iron ASTM A-48, Class 30
SEAL PLATE ...................... Cast Iron ASTM A-48, Class 30
IMPELLER:
Design ............ 10 vane, vortex, with pump out vanes
Material ........... Cast Iron ASTM A-48, Class 30
SHAFT ................................. 420 Stainless Steel
O-RINGS ............................. Buna-N
HARDWARE ....................... 300 Series Stainless Steel
PAINT .................................. Air dry enamel
SEAL Design ............. Single Mechanical
Material ........... Rotating Face - Carbon
CORD ENTRY ..................... 20 Ft. (6m) Cord with Plug on 115 Volt
MODEL NO HP VOLT/PH
PIP702B 0.5 115/1
Winding Resistance ± 5%.
on back side. Balanced, ISO G6.3
Stationary Face - Ceramic
Elastomer - Buna-N
Hardware - 300 series stainless steel
Pressure gromment for sealing and
strain relief.
Hz RPM NEMA
(Nom) START
CODE
60 3450 H
Pump rated for operation at ± 10% voltage at motor.
PUMP MODEL NO.
PUMP SERIAL NO.
SPEED ..................................3450 RPM (Nominal)
UPPER BEARING:
Design ............. Single Row, Ball, Oil Lubricated
Load ................ Radial
LOWER BEARING:
Design ............. Single Row, Ball, Oil Lubricated
Load ................ Radial & Thrust
MOTOR: Design ............. NEMA L Torque Curve. Oil Filled
Insulation ........ Class B
SINGLE PHASE .................. Permanent Split Capacitor (PSC)
LEVEL CONTROL .............. Wide Angle, PVC, Mechanical,
FULL CORD CORD
LOAD LENGTH SIZE
AMPS
6.4 20 ft. (6m)
FIGURE 1
3
Squirrel Cage Induction
Includes Overload Protection in Motor
20 Ft. (6m) Cord w/Piggy-Back Plug.
Normally Open (N/O)
CORD WINDING
TYPE RESISTANCE
MAIN -- START
14/3 SJTOW 3.5 -- 43
inches
(mm)