nLight nDTC Quick Start Manual

nLight® Digital Time Clock (DTC)
Quick Start Guide
Welcome to the nLight Digital Time Clock (DTC) Quick Start Guide. This guide provides quick instructions of how to properly mount the nDTC, and to
configure and create schedules on your new device.
Mounting Instructions
1
To mount, the faceplate must be detached from the
backplate. This will require an appropriately sized tool
(i.e., flat-head screwdriver) that can fit in the release tab.
3
Pull the backplate out from the bottom, away from the
faceplate, as pictured.
5
Pull all wires out of the wall and run them through the
central hole of the backplate. Screw the backplate onto
the wall.
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitybrands.com © 2019 Acuity Brands Lighting, Inc. All rights reserved. Rev. 09/05/2022
05AC-IGUNITNDTCW-10
2
Using the appropriately sized tool, press in the release tabs on each side of the device
until the backplate is noticeably released.
4
Device should be separated into two pieces, backplate and faceplate. The backplate will
be used to mount onto a wall gang box.
6
Plug the wire(s) into the connector(s), then gently push the excess wiring back into the
wall. Reattach the front plate and ensure that it clips tightly in place. Tighten the security
screw, if applicable.
1 of 6