Exposure Lights LINK Daybright User Manual

MAINTENANCE
Inspect and test your light and bracket apparatus before every ride.
Keep your light clean and free of dirt, be careful when cleaning any mud or dirt from lens to
avoid scratching.
Never use a high pressure spray or hose on your light.
Do not use harsh abrasive or corrosive materials to clean your light.
For extended periods when your light is not in use fully recharge the light once a month, as a long
duration with no charge is detrimental to the cells.
WARNING
Exposure Lights are very powerful lighting systems, please take care when operating. Do not
look directly into the light or shine directly at others, including other road users.
Exposure Lights / Ultimate Sports Engineering Ltd. accept no liability for any injuries or other
damages arising from the use of their product in any circumstances.
NOTE: Patents apply.
WARRANTY & SERVICE - LIGHT FOR LIFE
Please do not send any products back to us without contacting our service team first to
discuss your issue and for a valid returns number.
All our lights come with a 2 year warranty.
If you have a servicing or technical question you can contact us using the information below. If you
return your light for repair, no work will be carried out until you have been contacted with the cost
for the repair. If you are outside of the UK it would be quicker in the first instance to contact your
local distributor.
+44 (0)1798 839300
service@use.group
Ultimate Sports Engineering Ltd
Unit 4 Bury Mill Farm
Bury
West Sussex
RH20 1NN
United Kingdom
#ownthenight
For more information please visit: For more information please visit:
exposurelights.com exposurelights.com
EXPUG1.4
EXPUG1.4.indd 1-3 EXPUG1.4.indd 1-3
LINK • LINK + • TRACE • TRACER • TRACER ReAKT
CHARGING
Fully Charge your light before first use.
Locate the USB charging port by pulling away and down on the tab of the silicone band where the
USB symbol is etched onto the light's body.
Fully insert the USB charging cable and
begin charging from a USB supply.
An LED behind the lens will flash
green to indicate that it is charging
and then turn solid green when the light
is 95% charged, then the remaining 5%
is trickle charged.
Approximate charge times from a 500 mA
supply are:
Link/Trace/TraceR: 1.5 hours
Link+: 7 hours
IMPORTANT: After charging is complete correctly replace the silicone band to prevent water ingress.
LIGHT OPERATION & BATTERY LIFE
To turn the light on press the function button twice in quick
succession.
Trace/TraceR: The light will turn on in the mode that was last
used. A single press of the function button will cycle between
a constant beam and a pulse.
Link/Link+: The light will turn on in the mode that was last
used. There are 7 modes that include having either the front
or rear LED lit, press the function button once to cycle to the
next mode.
To turn any of the above lights OFF hold the function button
down until there is a double flash and then release.
Immediately after the light is turned off the LED colour
indicates the percentage (see table) of the remaining battery
life, functioning as a 'Fuel Gauge'.
USER GUIDE
HANDLEBAR MOUNTING - TRACE
WARNING: Ensure that brake and other cables do not catch on the light or its bracket.
HELMET MOUNTING - LINK & LINK+
Try the short bolt first - if this isn't long enough use the longer bolt. Do not over-tighten.
Function Button
Fuel Gauge
Requires a
LED COLOUR BATTERY %
5mm hex-key
GREEN 100 - 50
AMBER 50 - 25
RED 25 - 5
RED FLASH 5 - EMPTY
NOTE: The angle of the light can be adjusted by rotating and tilting the ball joint.
BAR
HELMET
HELMET
13/08/2020 14:52 13/08/2020 14:52