Subscribe to Our Youtube Channel
Related Manuals for GGM gastro BD-32
Summary of Contents for GGM gastro BD-32
- Page 1 UPRIGHT FREEZER INSTRUCTION MANUAL Model No.: BD-32 To ensure proper use of this appliance and your safety, please read the following instructions completely before operating this appliance.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Before Putting Into Use…………………………………………………………………..2 Tips For Energy Saving…………………………………………………………………..2 Important Safety Instructions…………………………………………………………….2 Correct Disposal of this product................4 Name Of The Parts………………………………………………………………………..5 Specifications………………………………………………………………………………5 How To Operate: Starting Your New Refrigerator…………………………………………………...6 Temperature Control……………………………………………………………… 6 How To Defrost……………………………………………………………………. 6 Level your freezer…………………………………………………………………..7 Door alignment....................7 Door Reversal Instruction……………………………………………….……..…. -
Page 3: Before Putting Into Use
BEFORE PUTTING INTO USE Before connecting the appliance to the power supply, let the unit stand upright for 4 hours, which will reduce the possibility of the cooling system malfunctioning due to improper handling. Clean your unit thoroughly before putting into use. (See “How to Clean”) ... - Page 4 2) Do not tip over the unit. 3) If the freezer is brought in from outside in wintertime, give it a few hours to warm up to room temperature before plugging it in. 4) Repair or replace immediately all electric service cords that have become frayed or otherwise damaged.
-
Page 5: Correct Disposal Of This Product
IMPORTANT: The wires in this mains lead are colored in accordance with the following code: Green or Green with a strip yellow: Grounding Blue: Neutral Brown: Live During using: Do not touch the cooled surfaces while the appliance operates, especially not with wet hands, because the skin may stick to the cold surfaces. -
Page 6: Name Of The Parts
NAME OF THE PARTS Model No.: BD-32 ⑴ Wire Shelf ⑵ Bottom foot ⑶ Door assembly ⑷ Top hinge cover ⑸ Freezer Compartment ⑹ Temperature Thermostat Box(not shown, located at the back) SPECIFICATIONS Product Description Upright freezer Model No. BD-32... -
Page 7: How To Operate
HOW TO OPERATE Starting Your New Freezer Clean the freezer thoroughly. Wipe the outside with a soft dry cloth, the interior with a clean moist cloth. Insert the power supply cord into the socket. Turn the thermostat dial to “7”. Close the door and let the unit operate for 2-3 hours. Reduce the thermostat to a mid-range setting “3”-“5”... -
Page 8: Level Your Freezer
Leveling Your Freezer Door Alignment Door Reversal Instruction We supply you the freezer with left side open door or right side open door. Please buy the correct unit according to your installation location. If you are not sure, or want to change the location, please reverse the door refers to the following figure and explanation according to your new installation location. - Page 9 Your freezer is built with a reversible door. You have the choice of either opening it from the left or the right side. In order to reserve the opening direction of your door, please follow these simple instructions: Remove all goods out of your freezer. Tilt the freezer backwards. Secure the rear from sliding. Tape the door to the cabinet to prevent from falling.
-
Page 11: How To Clean
HOW TO CLEAN Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on any surface. Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic waxing, use silicon wax. Freezer: When unit needs defrosting turn thermostat to “OFF” (“0”). Do not use sharp metallic instruments to scrap off ice/frost. -
Page 12: Troubleshooting Guide
Do not modify the power cord under any circumstance to allow the unit to be plugged into a non-grounded outlet. To avoid heat damage to the power cord, please ensure that it does not come in proximity or in direct contact with the compressor of the refrigerator. Please avoid installing the refrigerator in a location where the appliance will come in contact with water or moisture to minimize rusting of metal parts. -
Page 13: Refrigerator Warranty
When condensation forms on the outside of the refrigerator: Condensation may form on the outside when the humidity level is high such as during a wet season. This is the same result as the condensation formed when chilled water is poured into a glass.
Need help?
Do you have a question about the BD-32 and is the answer not in the manual?
Questions and answers