Advertisement
Quick Links
Front Wishbone Bush Tool for VAG
GENERAL INFORMATIONS
This tool set is designed for the removal / installation of the rear mounting bush on the front lower
wish bone and can be used without removing the wish bone. The tools are suitable for Seat Cordoba
III (2003 on) - Skoda Fabia (2000 on) - VW Polo IV (2002 on).
IMPORTANT
Read these instructions carefully. Note the safe operational requirements, warnings and cautions.
Use the tool correctly and with care for the purpose for which it is intended. Failure to do so may
cause damage and personal injury and will invalidate the warranty. Please keep instructions safe for
future use.
WARNINGS
Ensure Health and Safety, local authority and general workshop practice regulations are adhered
•
to when using tools.
Do not use the tools if there are damaged.
•
Maintain tools in good and clean condition for best and safest performance.
•
Ensure that a vehicle which has been jacked up is adequately supported with axle stands and
•
that the wheels are chocked, refer to the vehicle manufacturer's service instructions, or a
proprietary manual.
Wear approved eye protection.
•
Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
•
Do not use air tools to operate the force screw.
•
Failure to heed safety and warning instructions may result in damage and personal injury and will
•
invalidate the warranty.
The warnings, cautions and instructions referred to in this manual cannot cover all possible
•
conditions and situations that may occur. It must be understood that common sense and caution
are factors which cannot be built into this product, but must be applied by the operator.
IMPORTANT:
The force screw must be kept well lubricated.
This manual is provided as a guide only, refer to the vehicle manufacturer's service instructions, or a
proprietary manual, to establish the current procedure and data.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Art. 8589
Advertisement
Summary of Contents for BAG 8589
- Page 1 Art. 8589 Front Wishbone Bush Tool for VAG GENERAL INFORMATIONS This tool set is designed for the removal / installation of the rear mounting bush on the front lower wish bone and can be used without removing the wish bone. The tools are suitable for Seat Cordoba III (2003 on) - Skoda Fabia (2000 on) - VW Polo IV (2002 on).
- Page 2 TOOLS 1 Dismantling pressure piece 2 Dismantling sleeve 3 Installation piece (bush side) 4 Installation piece (wishbone side) 5 Nut 6 Bolt NOTE Pictures taken with the wish-bone removed from it’s housing for clarity. Refer to the vehicle manufacturer’s service instructions, or a proprietary manual to carry this out. The pictures are of an off-side bush being replaced.
- Page 3 1. Assemble the dismantling tools as in Fig.1. Thread the Adaptor (A) onto the short threaded end of the bolt (6) with the ridged side facing forwards. Pass the bolt through the bush from the rear and then position the large Adaptor (2) over the bolt, fitting it against the housing with the cut-out facing inwards and the small recess fitted over the rubber locator on the bush.