Advertisement
WIRELESS WALL ADJUSTER – ST FIELD ASSEMBLY
7. Prepare resistance heaters following Heater Sub-
Assembly Instructions (attached). Slip shrink band
and heater over the thermostat. Locate the space
between the ends of the heater at the bottom of the
thermostat (where the heat will be applied to the
shrink band). One edge should be against the hub
of the thermostat. Heat the shrink band with a hair
dryer until the band is tight.
8. Rout the wires through the
and through the grommet in the
housing (see Fig. 4).
9. Connect the red wire(s) and the black wire(s) to
terminals labeled INTERNAL HEATER (see Fig. 5).
10. Route the plug connector on the ribbon cable for the
button/label through the grommet in the
in the housing.
11. Connect the plug connector to the three pin
connector on the wireless diffuser board smooth
side up.
12. Secure the adhesive backed button/light to the
room side of the diffuser housing near the edge
where it can be easily reached for the joining
process to follow (see Fig. 6).
13. Fit the cover onto the wireless diffuser board.
14. Fold up and latch the appearance panel.
For installation and maintenance instructions please
see Form 040.204 Wireless Wall Adjuster Installation
and Operating guide.
1
/
" hole in the scoop
4
5
/
" hole in the
16
5
/
" hole
16
Page 2 of 3
Fig. 4
Connect button/light
smooth side up
Connect red
and black
wires here
(not used)
Fig. 5
Fig. 6
Adjuster-W ST Field Assy 170505.doc
WRAP
Advertisement
