Power Test - CyberData 011376 Quick Start Manual

3.0 Power Test

3.1. Plug in the CyberData device and monitor the LED activity above the
ethernet port on the back of the SIP RGB Strobe. See the following figure:
3.2. The GREEN
comes on again and remains constant (solid GREEN). The
Activity LED may be blinking depending on the network activity.
Normally, this process will take about 30 seconds. However, if no DHCP is
available, then this process could take up to 2 minutes.
This concludes the power test. Go to
in a Test Environment".
Quick Start Guide
Activity
Link LED blinks off once during the boot up process and then
Link
Section 4.0, "Connecting to a Network
YELLOW
931215B