Anaren BoosterPack CC2530 Quick Start Manual

Check out the other available BoosterPack kits, available at
http://www.anaren.com/air-boosterpack
IMPORTANT NOTE: The BoosterPack
following regions:
US (default): USA FCC / Canada IC
If the intended location of use is not within these regions, you must first check with local regulatory
agencies to determine if any permissions / license / etc. are required prior to operation.
See Disclaimers and Regulatory Information included with the kit for more information.
Caution! The AIR-BoosterPack contains ESD sensitive compo-
nents. Precautions should be used when handling the device in
order to prevent permanent damage.
67150-0003
is designed to comply with regulations in the
EU: Europe ETSI
http://www.anaren.com/air
CC2530 BoosterPack Quick Start Guide (MSP430
The Anaren Integrated Radio
wireless connectivity for the TI
simple instructions below and you'll be 'on the AIR' in minutes.
This kit contains:
BoosterPack
2xAA battery
with MCU (3)
pack (1)
Layout & Function:

Network Overview:

each of which can be configured to one of the three basic roles of a mesh network
Coordinator (C): A node that assigns
the network ID to other nodes, and
routes data to/from nodes on the
network; for proper operation there
must be one, and only
Coordinator on the network
Router (R): Like the Coordinator, but
does NOT assign network IDs
End Point (E): Sends information to/
from a Coordinator or Router, capable
of sleep mode
Individual BoosterPacks
1244a
flashed on the BoosterPack MCU.
default) by loading the desired image from the CD.
added to the network from additional kits. See User's Manual for more information.
(AIR) BoosterPack kit is designed to provide instant
LaunchPad Development Tool. Just follow the
You will also need:
Computer
Software
CD (terminal
emulation)
See User's Manual for full description of all features
A AIR radio module
B Control switches
C "LaunchPad" switches & LEDs
D Sensors
(IR temperature, RGB light)
E EEPROM
F Tri-color LED
G Current sensor
(module or full-board)
H MCU (pre-mounted & flashed)
2
I I C and SPI external connection
J AIR module LEDs (2)
The AIR BoosterPack kit includes three BoosterPacks,
Typical
one,
Additional nodes
added to network
are assigned their role on the network by the firmware
Their role may be changed (or returned to
BoosterPacks
Continue on to get your kit running...
)
TM
You may
also want:
Laptop
Soldering iron
Solder
IC puller
X-jumper
USB battery
LaunchPad Tools /
(3) supplies
:
Two End Points
may also be