• The fitting must be properly connected to the flexible 1.1 Introduction tube/pipe system. • These instructions apply to series 7F400 Inline Filter, • Before installing the fitting make certain that external also referred to below as fittings. mechanical effects such as thrust and bending forces •...
2 Manufacturer’s Specification 3.2 Dimensions 7F400FTC 2.1 Description The Inline Filter 7F400 cleans the used gaseous media of particles. 2.2 Transport and Storage • The fitting must be protected against mechanical da- mage, moisture, dirt and dust. The storage temperatu- re range is 10 – 40°C.
All data in mm 3.7 Dimensions 7F400TT 3.5 Dimensions 7F400TCF Ø D Ø D ~ L1 04/06 G1/4“ 16.5 SW14 All data in mm All data in mm www.em-technik.com EM-Technik GmbH - Industriestraße 2 - 67133 Maxdorf - Germany info@em-technik.com...
1,190 Nl/h air ∆P 0.1 bar • If a plastic fitting is used in combination with a metal- Filter surface 0.9 cm² lic male fitting, additional sealing with Teflon® tape is recommended. www.em-technik.com EM-Technik GmbH - Industriestraße 2 - 67133 Maxdorf - Germany info@em-technik.com...