Table of Contents
Advertisement
LampizatOr- The Horizon DAC Manual
A quick guide to a smooth start
THE BUTTONS
The whole DAC can be operated simply by the three buttons on the front.
Left and right button are simply VOLUME UP and DOWN.
When you hopld the button the volume change will accelerate to the end of the scale.
Middle button is a POWER ON while DAC is in STANDBY mode and it is input selector
when the DAC is in the operation.
The Nixie display will show the selected input number for 3 seconds. After that it will jump
back to showing the volume level.
1 = SPDIF, 2 = AESEBU, 3 = Toslink, 4 = USB, 5 = HDMI i2S, 6 = RJ45 i2S, 7 = Analog
RCA input, 8 = analog XLR balanced input
MAINS VOLTAGE: All DACs are shipped with the voltage of MAINS according to the
country of destination. If you bought the DAC second hand and you are in different voltage
zone - the DAC can be converted by a switch at the bottom, allowing user to select mains
voltage.
It requires placing the DAC on the side and sliding the 115/230 switch to the oposite
position, firmly to the end of slide.
POWER CABLE (MAINS)
It is not necessary, but advisable that the power cable used is a quality one, not simply
a computer cable. It is also advisable to use some kind of AC filter – in many cases this
brings nice results. Generally under-filtering is better than over-filtering.
Due to multitude of AC plugs around the world - we dont supply any AC cable at all.
7
of
32
! 7
Advertisement
Table of Contents
