Gastec 351A-30 Instruction Manual

30m Extension hose No.351A-30
■FOR SAFE OPERATION
Read this manual, the instruction manual of your Gastec Gas sampling pump, and the instruction manual
of your Gastec Gas detector tube carefully.
CAUTION
NOTE
■Specifications
Product name
Product code
Length
Outer / Inner diameter
Weight
Applicable with
Optional parts
■MEASUREMENT PROCEDURE
the instruction manual of your Gastec Gas detector tube carefully.)
1. Replace the rubber inlet flange clamping nut of the sampling pump by the metal clamping nut of the
extension hose. The metal clamping nut should be firmly tightened to eliminate leakage caused by poor
seal between the flange of the rubber inlet and the pump body.
2. Insert the nipple of the extension hose securely into the pump inlet.
3. Tighten the metal retaining nut firmly and fix the tubing on the pup head.
4. After breaking off tube tips, place the tube into the rubber shroud of the extension hose. The tube must
be attached in the holder so that sample is drawn into the pump in the direction of the arrow (►)printed
on the tube.
5. When use of twin tube, connect rubber tube shroud No. 358 which is sold seperately.
Instruction manual
If not observed, injuries to the operator or damage to the product may result.
When breaking the tube ends, keep away from eyes.

Do not touch the broken glass tubes, pieces and reagent with bare hand(s).

For maintaining performance and reliability of the test result.
Use only Gastec Gas Sampling Pump (GV-100 or GV-110).

Refer to the instruction manual of your Gastec Gas Detector tube for use temperature

and humidity range.
Avoid sunlight, acids, and alkaline materials.

30 m Extension hose
No.351A-30
30m±2%
φ5 mm / φ1.5 mm
900g (approx.)
GASTEC Gas sampling pump model GV-100 or GV-110.
Rubber shroud No.358
(Read the instruction manual of your Gastec Gas sampling pump and