Page 1
9731 INSTALLATION MANUAL Dear customer, should you have any questions, please contact your distributor immediately; for more information, please visit our website: www.acritec.com Maintenance tip: The following substances or articles may cause physical harm and/or damage the shower door. Do not use them for cleaning.
Page 4
Make sure the shower tray has been installed correctly, and ensure it is plumb, level and square. Step 4. Finished Wall Surface Level the wall jambs vertically,middle in the center use a pencil to mark hole locations. Step 1. Find out the centre of shower fray threshold and the centre of the angle front.
Page 5
ST3.9x8 "× " Step 7. Secure the short support rod (part #9) in the hinge post. Step 8 Slide the fixed panel into the wall jamb on each side.
Page 6
ST3.9x25 Step 9. "×1" Set the bottom of the pivot door in the hole of the bottom pivot bracket, using the pivot bushing (21). This pivot bracket is preassembled. Step 10. Put the top pivot bracket with a hole (6) all the way down over the support rod and secure it with screws (28).
Page 7
Step 14. Install the handle in the door, using the approiate washers and bushings supplied (14). Step 15. Set the aluminum threshold (13) on the shower tray. Adjust the width and use the To the screws (20) tp secure each end to the inside pivot bracket.
Page 8
inside of the ST3.9x8 "× " Step 17. After final adjustment, the door should be in place. Drill 1/8'' holes in the wall jambs through the predrilled holes on the fixed panel and secure with screws (18). Put the screw covers on top of screws (19).