Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Camatics VT2500
- Page 1 Camatics Fitting Guide 19 May 2022...
-
Page 2: Table Of Contents
Installation _____________________________________________________________________ 7 Preparation _________________________________________________________________ 7 Hardware __________________________________________________________________ 7 Wiring _____________________________________________________________________ 7 G-Sensor Calibration __________________________________________________________ 7 Camatics Job Sheet ___________________________________________________________ 8 SD Card Replacement _____________________________________________________________ 9 Items Required ______________________________________________________________ 9 Instructions _________________________________________________________________ 9 SIM Card Replacement ___________________________________________________________ 10 Items Required _____________________________________________________________ 10... -
Page 3: Important Information
• If you have any questions or concerns regarding this document, the hardware you have received or the requirements of your Camatics Insurance Policy, please contact you broker immediately. • Before you begin installing and commissioning the system, please ensure that you have read this manual thoroughly, referring to any supplementary information provided for the unit as required. -
Page 4: Installation Dos And Don'ts
’ NSTALLATION OS AND 3.1 P OWER The device MUST be wired to its own power supply and not connected/shared with an existing power pickup point. We recommend that the vehicle power pickup points should be located using the vehicle manufactures instructions. -
Page 5: Introduction
NTRODUCTION 4.1 F RONT 4.2 S... -
Page 6: Back
4.3 B Working Status LEDs Blue Solid Green Solid 4.4 P OWER ABLE OLOURS... -
Page 7: Functions
UTOMATIC OOTING Once the VT2500 has been wired to your vehicle power source, the VT2500 will boot up. This will take around 1 minute for the unit to be ready to record. Please note, the unit will not start recording immediately after the power is on. It takes around 1 minute for the built-in power backup system to charge. -
Page 8: Installation
IRING The VT2500 requires a continuous 12/24volt power source from the vehicle. The cable supplied will allow you to hard wire the VT2500 unit to the fuse box of your vehicle. Connect the “red cable (+)” to a fuse. It should be connected to a fuse that has power only when you start the engine. -
Page 9: Camatics Job Sheet
6.5 C AMATICS HEET Please go to https://www.camatics.co.uk/newjobsheet and complete the Camatics Job Sheet. You will require the following: • Policy Number • Vehicle Registration • Device DRID – found on the device’s green sticker • Photo of the inside of the vehicle showing the camera affixed to the windscreen •... -
Page 10: Sd Card Replacement
4. Pull the SD card out of the VT2500 and put it aside 5. Push the new SD card into the VT2500 until you hear it click, it should sit flush with the casing 6. Place the protective cover back over the end of the VT2500 and use the screw to secure it in place 7. -
Page 11: Sim Card Replacement
4. Pull the SIM card out of the VT2500 and put it aside 5. Push the new SIM card into the VT2500 until you hear it click, it should sit flush with the casing 6. Place the protective cover back over the end of the VT2500 and use the screw to secure it in place 7.