Compliance And Approvals - Husqvarna Multi Sling Operator's Manual

The following standards are applied:
• EN 795B:2012
• EN 354:2010
• EN 566:2017
• ANSI Z133-2017
• AS/NZS 5532:2013
The product accompanied by this set of instructions
is type-examined, CE-marked to state conformity with
the European regulation (EU) 2016/425 on Personal
Protective Equipment (PPE) and meets the European
standards given on the product label. The product
does however not comply with any other standards
unless explicitly stated. Notified body 0408: TÜV Austria
Services GmbH, Deutschstrasse 10, A-1230 Vienna,
Austria.
This product was tested to EN 795, Class B, for use by a
single person using Personal Protective Equipment.
Pursuant to EN 795, this product for Personal Protective
Equipment must be capable of withstanding a force of
18 kN in every described mode of use when new.
EN 566:2017 and ANSI Z133-2017:
• Breaking load to EN 566 at the time of manufacture:
22 kN.
• The product meets the requirements of the ANSI
Z133-2017 standard as regards the required
minimum breaking load (MBL) for climbing ropes
and prusik loops. It does not meet the diameter
requirements for climbing ropes. There exists no
diameter requirement for prusik loops.
Declaration of Conformity is available on
www.husqvarna.com. Use the search function and
search for the product.
Responsible manufacturer: Husqvarna AB, SE-561 82
Huskvarna, Sweden, tel: +46-36-146500
10

Compliance and approvals

1781 - 003 - 13.06.2022