Maintenance - FDA Cleared DW-11A User Manual

Maintenance

Adjust the Tightness of the Track and Replace it
Note: The original manufacturer or dealer has adjusted the tightness of the track before leaving
the factory.
When the track is loose or too tight, it is necessary to adjust the tightness of the track.
1) Tighten: Use the Allen wrench in the tool as shown in the figure to insert the adjustment hole.
(As shown in the picture on the right) Turn the wrench clockwise to adjust the track until it is
tight (each track has two adjusters, please adjust them separately to keep the track balance.
2)Relaxation: Use the Allen wrench in the required tool as shown in the figure to insert the
adjustment hole. (As shown in the picture on the right) Turn the wrench counterclockwise to
adjust the track until it is tight (each track has two adjusters, please adjust them separately to
keep the track balance).
18