Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Diamant Cipollini FLUSSO
- Page 1 OPERATION AND MAINTENANCE MANUAL FLUSSO #LiveYourRide...
-
Page 2: Table Of Contents
INDEX PG. 4 1 INTRODUCTION LIABILITY PG. 5 2 DESCRIPTION OF THE BICYCLE INTENDED USE GENERAL PRODUCT DESCRIPTION IDENTIFICATION PLATES BICYCLE COMPONENTS 2.4.1 GEAR CHANGE 2.4.2 SADDLE AND SEATPOST 2.4.3 HANDLEBAR 2.4.4 BRAKES 2.4.5 PEDALS 2.4.6 LIGHTS OPERATION AND MAINTENANCE MANUAL 2.4.7 PEDAL ASSISTANCE SYSTEM 2.4.7.1... -
Page 3: Introduction
Battery: Maxon Bikedrive Air 250 Wh Any alteration to the pedal-assist system, whether at the hardware or software level, immediately invalidates any liability of Diamant srl. Please note that pedal-assisted bicycles are considered as such if they comply with the EPAC standard which stipulates that the system only assists pedalling up to 25 km/h, for a maximum of 250 W and only following muscular pedalling applied by the user. -
Page 4: Identification Plates
IDENTIFICATION PLATES The FLUSSO pedal-assisted bicycle is equipped with an identification plate that certifies its approval according to EC regulations, in accordance with EN 15194 (2017). This plate must be present, legible and not removable, on the bicycle. Press the right shift paddle to move the rear derailleur outwards. Press and hold the paddle for multiple shifting. -
Page 5: Saddle And Seatpost
2.4.2 - L40UG Transmission group: SRAM Red AXS Type of control: wireless electronic SADDLE AND SEATPOST Number of gears: 24 (2 x 12) Before using the pedal-assisted bicycle, check that the adjustment screws are tightened as indicated near them and/or at the link The derailleur is also present in this variant. -
Page 6: Brakes
2.4.4 2.4.6 BRAKES LIGHTS All FLUSSO assemblies are equipped with a disc braking system that can In all FLUSSO models there is a rear light integrated in the seatpost. It is also be operated using the levers on the SRAM controls. The right lever activates advisable to affix reflectors (not supplied) after consulting the national and the rear brake, the left lever activates the front brake. -
Page 7: Switching On/Off The Assistance System
2.4.7.1 2.4.7.2 SWITCHING ON/OFF THE ASSISTANCE SYSTEM ADJUSTING THE LEVEL OF ASSISTANCE The assistance system is activated by pressing the power button circled in On the controller, you can set the e-Bike engine assistance level while the following image. pedalling. The level of assistance can be changed at any time, even while moving. -
Page 8: Compatibility With Cyclocomputers
2.4.7.5 To increase the level of assisted pedalling, briefly press the button highlighted in red on the following image, repeating the action until the desired level of assisted pedalling is displayed; to reduce the level, briefly press the button REPLACING THE REAR WHEEL highlighted in yellow. -
Page 9: Bicycle Cleaning
To insert the socket inside the connector on the bicycle, it is necessary to For cleaning and maintenance, it is necessary to have: raise the rubber cover and connect the charger in the appropriate socket. • A clean cloth Clean the cover of the charging socket. Avoid, in particular, the presence of •... -
Page 10: Inspection Intervals
INSPECTION INTERVALS WARRANTY Compliance with the inspection intervals is in the interest of the user to In addition to the legal guarantee according to Directive 99/44 EC, MCipollini ensure the proper operation and safety of the bicycle. MCipollini reserves the provides an additional Commercial Conventional Warranty on the frame of right, in the event of a request for action under warranty, to verify whether the pedal-assisted bicycle. -
Page 11: What To Do In Case A Warranty Intervention Is Needed
2. The services in execution of this Conventional Warranty will be rendered exclusively by the MCipollini Point of Sale at which you purchased the Product. To this end, the Buyer must contact only the Dealer at which the DISPOSAL purchase was made. To avoid any form of environmental pollution, MCipollini invites the end customer to dispose of the product and its packaging in accordance with 3. -
Page 12: Bike Transport
- The battery must not be subjected to mechanical shocks. battery. There is also a risk of fire and explosion. Diamant and Maxon will not - Do not step on the battery or throw it on the floor. - Page 13 - At the end of the charging process, it is recommended to disconnect the - Do not touch the plugs with wet hands. charger first from the power socket and then from the battery. - Do not use the charger plug and/or power plug if they are wet or dirty. Clean - Do not expose the charger to moisture (water, rain, snow) during charging.
- Page 14 Diamant SRL T. +39.045.6655044 info@mcipollini.it www.mycipollini.com www.mcipollini.com #LiveYourRide...
Need help?
Do you have a question about the Cipollini FLUSSO and is the answer not in the manual?
Questions and answers