Related Manuals for JENTNER DIGITAL II
Summary of Contents for JENTNER DIGITAL II
- Page 1 Operating Instructions Small-Size Electroplating Unit DIGITAL II and Digital V Jentner Plating Technology GmbH Johann-Staib-Strasse 2| 75179 Pforzheim – Germany Tel.: 07231 – 418 094-0 | FAX 07231 – 418 094-77 info@jentner.de www.jentner-plating.com...
- Page 2 Copper and Nickel. Dimensions and weight Digital II: Width 500 mm, depth 320 mm, height 250 mm, weight 16 kg Digital V: Width 820 mm, depth 350 mm, height 260 mm, weight 30 kg...
- Page 3 Side 3 – Operating Instructions DIGITAL II and V Operating elements ❶Button „Start/Standby“ ❷Button “Motor/Movement“ ❸Button „Heizung/Heater 1“ ❹Button „Heizung/Heater 2“ ❺Control panel / display ❻Button “Temp” – setting temperature ❼Button “Volt” – setting voltage ❽Button “Charge” – setting Amin (charge) ❾Button “Time”...
- Page 4 Side 4 – Operating Instructions DIGITAL II and V The anode rods ⓱ can be pulled out very easily, the cathode rod ⓲ in the middle can be screwed out (clockwise). Agitation (cathode rod) The movement is effected by a built-in driving motor. The movement can be started with the button ❷...
- Page 5 Side 5 – Operating Instructions DIGITAL II and V Start up The delivered power plug which is equipped with protective earth contacts has to be connected with the power plug port situated on the backside of the machine. Then put the other end of the cable into an electrical power point 230 V / 50 Hz (120 V / 60 Hz).
- Page 6 Side 6 – Operating Instructions DIGITAL II and V Programming of the DIGITAL II and Digital V Display NOM. VALUES Temp. 1 40°C Temp. 2 10°C 6,0 V 23°C 0,0 A time 00:45 0°C 6,0 V 0,00 Amin Temp Volt...
- Page 7 Side 7 – Operating Instructions DIGITAL II and V By setting the charge, the metal weight is determined. For the Rhodiumbath a setting of 10 Amin would be mathematically a deposition of 60 mg (10 Amin x 6 mg / Amin = 60 mg). Please note, these are purely theoretical values, which may differ from the actual values.
- Page 8 Side 8 – Operating Instructions DIGITAL II and V Control functions 1. Heat protection / level regulator If the level is too low in a heated bath the heater is switched off by the thermo couple. The display shows a warning signal over the full area. The signal can be confirmed with “ok” but the heater remains off.
- Page 9 Side 9 – Operating Instructions DIGITAL II and V Symbols of the display Amin Total charge exceeded Total charge all right Heater on Motion on Unit on Permanent operation Digital II_V_PB.en Side 9 of 9 Issue May 2016...