aci OUTSIDE AIR Series Installation & Operation Instructions

OUTSIDE AIR SERIES
TEMPERATURE TRANSMITTER
Installation & Operation Instructions
GENERAL INFORMATION
The ACI Outside Air Series sensors and transmitters
are single point sensors that output 4-20 mA with an
optional voltage signal output of 1-5VDC or
2-10VDC signal to BAS or controller. All ACI/TT and
TTM temperature transmitters can be powered from
either an unregulated or regulated 8.5 to 32 VDC
power supply.
MOUNTING INSTRUCTIONS
For optimal temperature measurement, follow
these tips:
• Avoid mounting to chimney walls, above
windows, above vents, near doors, or dampers.
• Mount at least 1'-2' (0.3-0.6 m) below eave to prevent
thermal radiation from affecting performance –
see FIGURE 2 (p. 2).
• Mount at least 4' (1.22 m) above ground to prevent
thermal radiation
performance.
• Mount in shade on North side of the structure to
minimize sun exposure.
hemisphere the South side of the building is
where the sensor should be mounted.
• The plastic tube that houses the sensor must be
pointed down to avoid debris, water, or ice
potentially a ecting sensor performance.
Attach the base directly to the wall. Mounting holes
are located at the corners of the housing – see
FIGURE 1 (right). Drill pilot holes for the mounting
screws. Use the enclosure mounting holes as a
guide, or use the dimensions listed below to
measure out. Install the PG11 watertight fitting
supplied with the sensor if not using conduit. The
outer knockout ring (PG 11/16) on housing
should not be removed when using a ½" NPT
conduit fitting.
Take care when mounting. Sensors should not be
placed in direct sunlight, or any other potential heating
or cooling sources that could a ect temperature being
sensed.
Automation Components, Inc.
2305 Pleasant View Road | Middleton, WI 53562
Phone: 1-888-967-5224 | Website: workaci.com
rising up a ecting
In the Southern
FIGURE 1: ENCLOSURE
DIMENSIONS
FRONT VIEW
NEMA -4X (-4X)
2.55"
(64.77 mm)
SIDE VIEW
-4X
2.23"
(56.71 mm)
MOUNTING HOLE LOCATIONS
-4X
1.96"
(49.784 mm)
Page 1
Phone: 1-888-967-5224
Website: workaci.com
EURO (-EH) BELL BOX (-BB)
4.00" 2.97"
(101.57 mm) (75.44 mm)
-EH -BB
2.12" 2.29"
(53.72 mm) (58.10 mm)
-EH -BB
2.69" 3.18"
(68.28 mm) (80.77 mm)
Version: 2.0
I0000857