Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Purelogic R Series
- Page 1 USER MANUAL CUTTERS DJTOL R Series DC CO2 Laser Tube...
-
Page 2: Table Of Contents
1 Safety ............................3 1.1 General ..........................3 1.2 Optical Safety ........................3 1.3 Electrical Safety ........................4 1.4 Others ..........................4 1.5 Declarations ........................4 2.Safety Marks ..........................4 2.1 Laser Warning Sign ......................4 3 Preparations and Installation....................5 3.1 Products Introduction ...................... -
Page 3: Safety
1 Safety 1.1 General Only authorized personnel who have been instructed in and fully understand the necessary safety procedures must use this laser or get in the vicinity. Access to the laser should be restricted to authorized personnel. Suitable warnings signs should be placed around the area where it is operating Any local safety requirements for the operation of this equipment must be complied with. -
Page 4: Electrical Safety
measures must be taken in this case. 1.3 Electrical Safety The power supply of this system is high voltage power supplies (DC 0-38Ma, 10kV-30Kv DC high voltage power supply) that should be installed and operated under the professional technicians’ instructions. WARNING: This equipment contains lethal AC and DC voltages. -
Page 5: Preparations And Installation
3 Preparations and Installation 3.1 Products Introduction R series laser tubes are our own patented technology, using physical methods to effectively optimize the output spot diameter, to improve the output power. And also, resolve the problem of spot modes altering. The resonator optics are from US II-VI Infrared, with a good spot pattern. New international catalytic technology is used to enhance the discharge coating layer and catalytic reduction performance, resulting in stable output and longer life. -
Page 6: Environmental Requirements
3.4 Environmental Requirements The R series lasers should be operated or stored in a dust-free condition the working or storage condition please refer to the Table 2. Below. The lasers PSU should be operated in a well-ventilated condition. The working area must comply with the local operation safety standards. -
Page 7: Operating Procedure
4 Operating Procedure 4.1 Start-up procedure Please switch on the laser in below sequence: （1）Turn on the water chiller. （2）Turn on the power to the PSUs （3）Set the correlative operation parameters to work. 4.2 Shutdown procedure Please shutdown the laser in below sequence. （1）Shutdown the PSU. -
Page 8: Problem: No Laser Output
6.2 Problem: No laser output. Possible reasons and solutions （1）Incorrect control terminal connections of the PSU or broken connection of control wiring. Please properly check the wires and the connections. （2）Failure of the water chiller, insufficient coolant in the water chiller reservoir. - Page 9 8 (800) 555-63-74 бесплатные звонки по РФ +7 (473) 204-51-56 Воронеж +7 (495) 505-63-74 Москва www.purelogic.ru info@purelogic.ru 394033, Россия, г. Воронеж, Ленинский пр-т, 160, офис 149 Вс Пн Вт Ср Чт Пт Сб выходной...
Need help?
Do you have a question about the R Series and is the answer not in the manual?
Questions and answers