Advertisement
DO NOT lift weights or exercise while occupying the product.
This transport chair has not been approved as a seat surface to be used within a vehicle. Transport chair
must be on a level surface when transferring user to or from seat. Footrests should be no less than 2 1/2
inches from the floor/surface.
HAND GRIPS
HAND BRAKE
FOLDING MECHANISM
MODEL: 352
BRAKE
12" WHEEL
FORK
8" WHEEL
1. Remove chair from the box and place it on the ground. Remove any cardboard protection and the
plastic from the wheels. (We recommend turning the box on the side and "rolling" out the Transport
Chair).
2. Bring the folding push handles upward fully to enlarge and lock the push pins into the frame of the chair.
3. Place both hands on the upholstery just to the inside of the seat tubes and push down and out until
the seat is fully opened. Your fingers could be pinched, therefore, be sure both hands and all fingers
are flat on the upholstery. Do not allow fingers to grab or reach the black tubes that secure the seat.
Continue to push down and outward until tubes engage into the seat supports. Please call NOVA
customer service if you have any questions.)
1. Pull upward on the middle of the seat from the front and rear until the chair is completely folded.
2. Release and fold down the back/push handles by pushing down on the release paddle and allowing
the handles to come down into a folded position.
1. First determine the left and right side by folding down the footplate and placing them in front of the
seat. The foot plates should be facing each other and directly in front of the seat.
2. Place the attachment plates with holes above the pins and slowly lower the holes onto both pins.
3. Swivel the footrests inward until the silver release lever engages and locks the footrest into the
forward position.
COMMON PART LOCATIONS
To Attach the Footrests
To Unfold
To Fold
3 of 8
HANDLE
BACK UPHOLSTERY
ARM PAD
ARMREST
SEAT UPHOLSTERY
FOOTREST
FOOTPLATE
Advertisement
