Javad MINTER User Manual
  1. Manuals
  2. Brands
  3. Javad Manuals
  4. Recording Equipment
  5. MINTER
  6. User manual

Javad MINTER User Manual

Hide thumbs

Advertisement

Table of Contents

MINTER
User's Manual
Revision May 31, 1999

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MINTER and is the answer not in the manual?

Questions and answers

Summary of Contents for Javad MINTER

  • Page 1 MINTER User's Manual Revision May 31, 1999...
  • Page 2 For updated manuals and software, or product release information you may visit JPS WWW site at http://www.javad.com or contact JPS Customer Support by e-mail support@javad.com. © Copyright 1998 Javad Positioning Systems. All rights reserved.
  • Page 3 Table of Contents GENERAL DESCRIPTION....................4 PWR KEY AND STAT LED.....................4 FN KEY AND REC LED ....................5 HOW TO CLEAR NVRAM....................5 CHANGE SERIAL A SPEED TO 9600 ................5 EXTENDED INFORMATION (EI) MODE ................5 INTERNAL MODEM OPERATION STATUS ..............6...
  • Page 4 • Shows data recording status. • Shows each time data is recorded to internal memory. MINTER has one Satus (STAT) LED and one Recording (REC) LED. Each LED has three colors: red, green, and yellow. MINTER has an ON/OFF key (PWR) and a function key (FN).
  • Page 5 Change Serial A Speed to 9600 MINTER has an option to turn baud rate of serial port A to 9600. To do that, press FN button and hold until REC LED becomes red (about 5 seconds), then release FN button while REC LED is red (during next 3 seconds).
  • Page 6 This information mode is available only if the receiver is equipped with an internal modem. To switch to mode, click either FN or PWR button on MINTER two times (one, if already in EI mode). 'Click' means push and quickly release (inside one second). To switch back to normal blinking click either button once again.

Table of Contents