WEBTEC 1 Series User Manual page 2

Meters with Bluetooth Contain Transmitter Module FCC ID: T9JRN4020 - IC: 6514A-RN4020
Tester mit Bluetooth enthalten Transmittermodul FCC ID: T9JRN4020 - IC: 6514A-RN4020
Débitmètres avec la fonctionnalité Bluetooth, contient un émetteur FCC ID: T9JRN4020 - IC: 6514A-RN4020
Medidores con Bluetooth contienen Módulo Transmisor FCC ID: T9JRN4020 - IC: 6514A-RN4020
EU - English
This product contains a Bluetooth® Low Energy Module which broadcasts in the license free ISM Band as follows:
l 2.402 to 2.480GHz
l Channels 0-39
l Transmit power: +7dBm
EU - Deutsch
Dieses Produkt enthält ein Bluetooth® Low Energy Modul, welches im lizenzfreien ISM-Band sendet und zwar wie folgt:
l 2.402 bis 2.480GHz
l Kanäle 0-39
l Sende-Leistung: +7dBm
UE - Français
Ce produit contient un module basse consommation Bluetooth® qui fonctionne avec la licence gratuite ISM comme
ci-dessous :
l 2.402 à 2.480GHz
l 0-39 voies
l Puissance transmise: +7dBm
UE - Español
Este producto contiene un módulo Bluetooth® de energía baja que emite en la licencia libre ISM Band de la siguiente:
l 2.402 a 2.480GHz
l Canales 0-39
l Potencia de transmisión: +7dBm
United States
Contains Transmitter Module FCC ID: T9JRN4020
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
Canada
This device complies with Industry Canada license exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Contains transmitter module IC: 6514A-RN4020
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne
d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de
sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante.