Switching Off; Malfunctions - FireWare Nebula User Manual

Manual
EN
FireWare Nebula
Charging the set
The remote and the smoke simulation goggles can be charged with a micro-USB cable that is
delivered with the set. As long as the set is charging, the orange LED will be blinking. When the
battery is fully charged, the LED will turn off.
Low battery:
• When the green LED next to the ON/OFF switch on the remote is blinking, the remote
needs charging.
• When the status LED on the goggles starts alternating green and red colour, the
goggles need charging.
• If the battery is low and the goggles are turned on, this will also be indicated by a few
short blinks of the goggles' screen.
• Please note
• When the goggles are indicating low battery, the status LED will not indicate the
connection status with the controller anymore.
• It is strongly advised that the controller and the goggles are recharged as soon as
possible after the low battery indication is observed. Also, please make sure that both
of the devices are turned off after the end of their use in order to avoid unnecessary
battery drain, which can also cause damage to the battery.
5.

Switching off

Please turn off the remote and the smoke simulation goggles after use. This will lengthen the
battery life and prevents unnecessary damage to the set.
6.

Malfunctions

Problem
No connection
No connection
Electronics
www.FireWare.nl
Cause
Out of range / no wireless
connection / panic button
activatedt
Low battery / no battery
Charger Plug in
Solution
Reset the set
Charge the set
Please contact FireWare
FireWare Nebula
19