ShowEx XMT-275 Vee Pro Quick Start Manual

XMT-275 Vee Pro Express Mount Kit

Mounting Instructions

IN BED EXPRESS MOUNT

Step 1: Locate left and right side mounting rail
Step 2: Locate item cross rails.
Step 3: Assemble items ,
Step 4: Install rear latches items
Step 5: Place frame assembly on truck and center left to right.
Step 6: Install items
,
bolt. To do this, you will need to bolt item
holes and then install items
Step 7: Determine front to back location by either placing spreader into locked position into frame assembly or by measuring
using rear side frame holes and measuring to rear of pick up bed. Mark holes with paint marker or scribe. Verify that
there are no critical components below the pick up bed such as a gas tank, etc.
Step 8: Drill holes and mount frame using supplied 5/8" hardware. Note: There are alternate holes for drilling around items that
may be in the way.

WHEEL KIT

Step 1: Assemble item
Step 2: Assemble items
Step 3: With spreader in truck, place item
Step 4: Place item on auger weldment and trap the lower edge while at the same time positioning item
so that item
Step 5: Lock swivel wheels.
Step 6: Pull spreader back and off the in bed mount, allow spreader to rotate towards ground with the locked wheels
touching first.
Step 7: Continue to pull spreader into a vertical position.
Step 8: When everything is stable, release wheel locks and slowly move spreader to storage location. Lock wheels when
final place has been established.
Step 9: See photo and drawing illustrations for assembly and installation.
Note: Ratchet straps must still be used as part of the mounting system.
4 — 25
and
, together per exploded view. (Accessory Shim
and with 5/8" thin lock nut
& per illustration. Note: on older models, you will have to drill out frame to accept item
, & .
to item using supplied hardware.
to item using supplied hardware.
wheel arm on the rear center of upper rail of hopper (see illustration/pictures).
pin with ring can keep the two assemblies together.
.
.
to lower frame rail using a drill template to locate the bracket, drill all four
may be needed for adjustment).
© Trynex International 2008
stop
to engage item
L1184