Advertisement
Quick Links
Advertisement
Summary of Contents for Butler's Choice BC6115BK
- Page 1 POWER NOZZLE TYPE: DS1601 MODEL: BC6115BK...
-
Page 2: Table Of Contents
Contents WARNING Parts List Assembly Opertion Maitenane troubleshooting... -
Page 3: Warning
IMPORTANT SAFETY INSTRUCTIONS! when using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS UNIT WARNING! To reduce the risk of fire, electric shock, or injury: Close supervision is necessary when any appliance is used by or near children. -
Page 4: Parts List
Parts List 1.Wheel cover plate 4.Front wheel axle 2.Front wheel 3.C-Clip 5.Furniture guard 8.E-Clip 6.Sleeve bearing 7.Rear wheel shaft 9.Rear wheel 10.Brush roller 11.Main PCB 12.Air duct partition plate 13.LED PCB 14.Height adjustment display window 15.Locking lever pivot 16.Rocker arm spring 17.Rocker arm 18.Rocker arm pivot 19.Height adjusting wheel spring... -
Page 5: Assembly
Assembly POWER NOZZLE ASSEMBLY 1.Push the wand 2.Fix the cord to the wand. into the swivel neck 3.Connect the wand with the hose of the power head handle and plug the cord into the until it clicks into receptacle on the hose handle. place. -
Page 6: Opertion
Operation The power nozzle designed with 5 height adjustment level. Choose an appropriate height level for different floor. Level 1 – shortest distance from the floor Level 5 – highest distance from the floor 3.Press the switch located in the hose handle to turn the power nozzle on and navigate the power nozzle back and forth to work. -
Page 7: Maitenane
Maitenane 3.Loop the new belt over the 4.Place the brush roller into 5.Place the top cover motor pulley first, and place the bottom base with the and replace the 8 screws the opposite end of the belt on round edge of the two on the bottom the brush roll pulley end-caps facing down. -
Page 8: Troubleshooting
Maitenane TROUBLESHOOTING Possible cause Possible solution Problem. 1. Electrical connection at hose Check the connection between the coupling not made. electrified hose and the power unit. 2. Power nozzle cord not firmly Motor is not working Plug cord firmly in plugged into the receptacle on the hose handle. - Page 9 DS1601-00000011...