Installation Instructions - GE GTDN500GMWS Installation Instructions Manual

Minimum learance Other Than Alco e or loset Installation
must
RE ARING FOR INSTA ATION
OF NEW DRYER
TI : Install your dryer efore installin your asher
This ill allo etter access hen installin dryer
e haust
DISCONNECTING GAS
TURN GAS
DISCONNECT AND DISCARD OLD
SHUT-OFF VALVE
FLEXIBLE GAS CONNECTOR AND
TO THE OFF
OLD TRANSITION DUCTING
POSITION.
MATERIAL. REPLACE WITH NEW
CSA(AGA) APPROVED FLEXIBLE
GAS LINE CONNECTOR AND UL
APPROVED TRANSITION DUCT.
WARNING
F E I E CONNECTORS
REMO ING INT FROM WA
E A ST O ENING
Remo e and discard e istin plastic or metal foil
transition duct and replace ith
duct
INTERNAL DUCT
OPENING

Installation Instructions

NE ER RE SE O D
listed transition
WALL
CHECK THAT EXHAUST
HOOD DAMPER OPENS
AND CLOSES FREELY.
TILT THE DRYER SIDEWAYS
AND REMOVE THE FOAM
SHIPPING PADS BY
PULLING AT THE SIDES
AND BREAKING THEM
AWAY FROM THE DRYER
LEGS. BE SURE TO
REMOVE ALL OF THE
FOAM PIECES AROUND
THE LEGS.
GAS RE IREMENTS
2
WARNING
Installation must conform to local codes and
ordinances or in their a sence the NATIONA F E
GAS ODE ANSI 22
This as dryer is e uipped ith a al e
Assem ly for use only ith natural as
con ersion it WE2
or ani ation can con ert this dryer for use ith
propane as A
RO ER TRAINED AND
IN A ORDAN E WIT
RE IREMENTS
The dryer must e disconnected from the as supply
pipin system durin any pressure testin of that
system at a test pressure in e cess of
The dryer must e isolated from the as supply pipin
system y closin the e uipment shut off al e durin
any pressure testin of the as supply pipin of test
pressure e ual to or less than
DRYER GAS SUPPLY CONNECTION
2"
2-5/8"
NOTE: Add to vertical dimension
the distance between cabinet
bottom to floor.
GAS S
AD STING FOR E E ATION
2
urner
sin
2 your local ser ice
ON ERSIONS M ST E MADE
A IFIED ERSONNE AND
O A ODES AND ORDINAN E
SI
SI K a
3/8" NPT MALE THREAD GAS SUPPLY
K a