VTech Fox & Friends Gift Set Instruction Manual page 5

INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the koala. Use a screwdriver to loosen
the screw and then open the battery
cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 1 new AAA (AM-4/LR03) battery following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
5
5
5