Download Print this page
ForPro Classic Hot Towel Warmer Quick Start Manual

ForPro Classic Hot Towel Warmer Quick Start Manual

Advertisement

Quick Links

Classic Hot Towel Warmer
Replacing the Bulb
continued
8. On the right side of the box, you can see two screws, screw out the two screws and open
the small cover of the box. See Fig. 5a & 5b.
Fig. 5a
9. Remove the faulty bulb. Insert a new bulb (Replacement bulb Item #391445) back inside the
small box, close the lid, and tighten the two screws on the lid. See Fig. 6a & 6b.
Fig. 6a
8. Tighten the screws of the UV box
8. Tighten the screws of the UV box
10. Reattach both lines and tighten the screws of the box. See Fig. 7a & 7b.
9. Install environmentally friendly cotton and backboard
9. Install environmentally friendly cotton and backboard
Fig. 7a
11. Replace environmentally friendly cotton and reattach back panel.
Troubleshooting
1. There is excessive moisture when the towel warmer is ON or the towels are heating up very
slowly.
• Check to see that the towels are only slightly damp. Excess moisture and/or slow heating
time may be a result of soaked towels.
2. The door is not closing properly and/or steam is escaping
• Check that the silicone door seal is in place. Push into door groove to assure proper fit.
Safety Precautions
Caution and proper procedures must be practiced at all times when using electrical appliances.
Basic safety precautions should always be followed, including the following:
• Do not use appliance for other than intended use.
Fig. 5b
• Do not place poisonous, flammable, explosive and evaporative chemicals into the towel
warmer.
• Do not touch hot surfaces. Use handle or knobs.
• To protect against electrical shock, do not immerse cord, plugs or appliance in water or
other liquid.
• Unplug from outlet when not in use and before cleaning. Cool the machine before
maintenance.
• Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions or has been damaged in any manner. If the product is defective, stop using it at
once and contact supplier for service.
• Do not use outdoors. This appliance is intended for indoor use only.
• Do not let cord hang over edge of table or counter, or touch hot surfaces.
• Close supervision is necessary when any appliance is used by or near children.
• Do not leave the appliance unattended when switched on.
• Extreme caution must be used when moving an appliance containing hot liquids.
Fig. 6b
• The temperature of accessible surfaces may be high when the appliance is operating.
• If using an extension cord, the marked electrical rating of the extension cord should be at
least as great as the electrical rating of the appliance.
Internal surfaces, wire baskets, towels and steam may be hot. Use with extreme caution
when removing hot towels or baskets. Always use protective heat-resistant gloves or
mitts to avoid steam or other burns. Ignoring the warnings may result in harm or serious
injury.
Fig. 7b
Item #303406 • New Hudson, MI 48165
www.tngworldwide.com • 800.520.6000
Made in China • ©2022 TNG
Classic
Hot Towel Warmer
IMPORTANT INSTRUCTIONS — RETAIN FOR FUTURE USE

Advertisement

loading
Need help?

Need help?

Do you have a question about the Classic Hot Towel Warmer and is the answer not in the manual?

Questions and answers

Summary of Contents for ForPro Classic Hot Towel Warmer

  • Page 1 Classic Hot Towel Warmer Replacing the Bulb Troubleshooting continued 1. There is excessive moisture when the towel warmer is ON or the towels are heating up very 8. On the right side of the box, you can see two screws, screw out the two screws and open slowly.
  • Page 2 Classic Hot Towel Warmer Operation Manual Congratulations on your purchase of the ForPro Classic Hot Towel Warmer. Please read Before Operation Replacing the Bulb the instructions and safety tips before use. Your Hot Towel Warmer comes with a one-year • Be sure to remove all packing material before use.