General Warnings; Delivery Content; Installing The Battery Pack - Bresser BR-20RGB Instruction Manual

GENERAL WARNINGS

DANGER OF BODILY INJURY!
Do not use in the presence of children or animals. Store out of reach
of children and animals.
Never touch parts of the device during operation or before it has
cooled down completely (approx. 45 min. after switching off)!
RISK OF GLARE!
Make sure that people and animals do not look into the light. The
high luminosity can cause glare to the eyes and afterimages. This im-
pairment of vision can lead to accidents.
RISK OF MATERIAL DAMAGE!
Make sure that no one can trip over connection cables of the device.
The device could be knocked over.
The manufacturer accepts no liability for damage to property caused
by improper or insufficiently safe installation!
Only use the recommended power supply unit or the recommended
rechargeable batteries .
3
The manufacturer accepts no liability for voltage damage caused by
the use of an unsuitable power adapter!
DANGER OF AN ELECTRIC SHOCK!
This device contains electronic parts that are powered by a power
source (power adapter). Only use the device as described in the man-
ual. Otherwise, you run the DANGER of an ELECTRIC SHOCK.
Never bend, squeeze or pull power cables, connecting cables, exten-
sions or connectors. Protect cables from sharp edges and heat.
Check this device, cables and connections for damage before use.
Never attempt to operate a damaged device, or a device with dam-
aged electrical parts! Damaged parts must be replaced immediately
by an authorized service agent.
Operate the device only in a completely dry environment and do not
touch the device with wet or damp body parts.
FIRE/EXPLOSION HAZARD!
Always place the device in such a way that it cannot tip over and en-
sure that it is stored in a reasonably safe place.
• Keep children and animals away from the device! They could knock
the device over.
• Make sure that no one can trip over connection cables. The device
could be knocked over.
• Do not expose the device to high temperatures. Do not short-circuit
the device or dispose of in fire! Excessive heat and improper han-
dling can cause short circuits, fires and even explosions!
• Never cover the ventilation slots or cooling fins of the device during
operation or until it has cooled down completely!
• Only use the recommended power supply
IMPORTANT NOTE!
Do not disassemble the device! In the event of a defect, please con-
tact your dealer. They will contact the Service Center and can arrange
the return of this device for repair if necessary.
Disconnect the power supply by pulling the mains plug when the ap-
pliance is not in use, in case of a longer interruption of operation and
before any maintenance and cleaning work.
Place your device so that it can be disconnected from the power sup-
ply at any time. The power outlet should always be near your appli-
ance and should be easily accessible, as the plug of the power cord
serves as a disconnect device from the mains supply.
To disconnect the unit from the mains, always pull the mains plug
and never pull the cable!
Do not subject the device to excessive vibrations.
unit or batteries !
4 3
1 PARTS LIST & DELIVERY CONTENT
Fig. 1
1.1 PARTS LIST
(Fig. 1-3)
 Battery latch & release  Battery slot  LED display
 UP button  MODE button  Decrease (-)  Battery charging port
 Increase (+)  Power switch  DOWN button

1.2 DELIVERY CONTENT

LED Light tube with rechargeable battery pack (1x), power adapter
with cable (1x), remote control (1x), NP-F550 battery (1x), bag (1x),
instruction manual (1x)
2 POWER SUPPLY
NOTE: This device is powered by a rechargable battery pack (Sony
type NP-F). Before commissioning, make sure that it is fully loaded.

3 INSTALLING THE BATTERY PACK

Make sure the switch is off and place the sufficiently charged and
compatible battery (Sony type NP-F) on the backside of the LED light
into the battery slot as shown by the arrows. Press the Power switch
to power on the device. Remove the battery after use.
Fig. 2
Fig. 3
(Fig. 1-3)