Summary of Contents for Taco Glen Dimplex System M
- Page 1 Powered By Glen Dimplex System M Air-to-Water Heat Pump Outdoor Unit HydroBox Building & User Interface Indoor Unit Installation and Operating Instructions Effective Date: July 15, 2022 Document #: 802-001 Plant #: 001-5040...
-
Page 2: Table Of Contents
Table of Contents 11. Decommissioning / Disposal........ 1. Please Read Immediately........12. Device Information..........1.1 Intended Use 13. Dimension Drawing..........1.2 Legal Regulations and Directives 13.1 Dimension Drawing Heat Pump 1.3 Energy Efficient Use of the Heat Pump 13.2 Dimension Drawing Legend 1.4 Inspection of Equipment 13.3 Dimension Drawing HydroBox 1.5 Handling of the Unit... -
Page 3: Please Read Immediately
45 degrees during shipment. If this label has been activated, notify the freight company and contact Taco customer service. Note: No one but a professional service technician should attempt to install, service, or repair this heat pump system. -
Page 4: Intended Use Of The System M Heat Pump
2. Intended Use of the System M Heat Pump 2.1 Area of Application 2.2 Operating Principle The air-to-water heat pump is to be used exclusively for heating or cooling of Heating HVAC system distribution water and indirect domestic hot water production. Surrounding air is drawn in by the heat pump's fan and fed through the It can be used in new or existing home comfort (HVAC) systems. -
Page 5: Scope Of Supply
English Air-/Water-Chiller-Heatpump 3. Scope of Supply Scope of supply 3.1 Basic Heat Pump Components 3.2 Basic HydroBox Components Evaporator (Air heat exchanger) Shut-off Valves 3.1 Basic device Fan (Water heat exchanger) Heat Pump Circulating Pump (M16) Switch box DHW Tank Circulating Pump (M18) 3.2 Chiller-heat pump manager Evaporator Compressor... -
Page 6: Transport And Access
Transport Air-/Water-Chiller-Heatpump English 4.1 Monoblock 4. Transport and Access A pallet should be used to transport the chiller-heat pump to its Transport final installation location. The basic device can be transported with a lift truck, hand truck or by means of 3/4" pipes fed 4.1 Heat Pump through the holes in the baseplate or frame. -
Page 7: Installation
For longer distances 1 1/4" pipe can be used. However, a resistance head calculation should be performed based on the supplied Taco 0034e circulating pump to maintain the target 8gpm flow rate with the chosen pipe size and pipe. -
Page 8: Assembly / Connection
6. Assembly / Connection 6.1 Installing the Electrical Wires 23.6” The electrical wires used to connect the HydroBox indoor unit to the Heat 33.5” Pump outdoor unit must be provided on site. Instructions on connection, wire recommendations, etc. are provided in the electrical documentation, section 6.6 and include 120 line voltage and a twisted pair, shielded communications wire. - Page 9 A Taco 4900 Air Separator is internal to the piping and a Taco Hy- Vent is connected at the top of the buffer tank. Both provide secondary air Minimum Heating Water Flow Rate elimination within the HydroBox.
- Page 11 System M - Heating, Cooling, & DHW; Typical Application Electrical Drawing Fig. 13A...
- Page 13 System M with Boiler Back-Up; Either Heat Pump Only or Boiler Only (Central heating boiler back-up, not DHW) Electrical Drawing Fig. 13B...
-
Page 16: Domestic Hot Water Connection
SMT85 DHW tank and the immersion heater, see section 6.6.1. A domestic hot water recirculation system can be used as part of the overall system design, such as the Taco SmartPlus-e, Hot-LinkPlus-e or TacoGenie. These systems are installed and controlled separately from the System M. - Page 17 ANSI Y14.5 INCHES [MM] ANGLES ± 1° THIS DOCUMENT CONTAINS INFORMATION THAT IS CONFIDENTIAL AND PROPRIETARY TO TACO, INC. (“TACO”). IT IS PROVIDED FOR USE ONLY FOR THE PURPOSES EXPRESSLY STATED BY TACO. BY USING DATE SCALE SHEET 07/16/2020 THIS DOCUMENT, YOU AGREE THAT TACO WILL HAVE NO LIABILITY...
-
Page 18: Electrical Connection
6.6 Electrical Connection 6.6.1 Electrical Diagrams... - Page 19 System M Electrical Rough-in Diagram Electrical Rough-in Diagrams Optional Forced Cooling Change-over Outdoor Indoor (Dry Contacts) Outdoor Sensor Optional Heating Demand; Smart Grid 2 (Dry Contacts) Optional 1 +VDC Heating/Cooling DHW Tank Field Wiring Circuit Pump Sensor (0-10VDC) Ethernet Cable 120/1/60 Indirect Indoor Unit...
- Page 20 In the lower section of the wiring hub is all the low voltage connection. Fig. 15 Required connections for proper operation of the System M includes: • Communication between the Heat Pump outdoor unit and HydroBox indoor unit: The Modbus communication cable must a 24 AWG shielded, single twisted pair (or CAT 6).
-
Page 21: Touch Screen User Interface And App
System M operation through a 0-10vDC signal (terminal 12 & 13). The circulator must be able to accept a 0-10vDC signal, such as the Taco 0034e, VR3342, VR15-30, or 00-VV products. Using this circulator as the primary loop pump for the... -
Page 22: Set-Up Of The System M
(or the address entered during the set up) and also stored by Taco / Dimplex for future technical To close the screen swipe right starting reference, if needed. -
Page 23: Air Purging
10. Faults / Troubleshooting This heat pump is a quality product and is designed for trouble-free Although a high-performance Taco 4900 Separator is installed in the operation. In the event that a fault should occur, it will be indicated on the HydroBox (vent shipped in the closed position), it is recommended that user interface display. -
Page 24: Device Information
12. Device Information Specifications System M-1 Air-to-Water Chiller Heat Pump Outdoor Unit with HydroBox Design Building + User Interface Indoor Unit 1.1 Heat pump model AWCHP-9HC 1.2 HydroBox Model HBSM-1 1.3 Heat pump manager controller SCU-1 1.4 Heat pump installation location Outdoor 1.5 HydroBox installation location Indoor... - Page 25 Specifications System M-1 5.9 Heat pump nominal power consumption A2/W35 in °C (A36 /W95 in °F) / max. consumption kW (BTU/h) 1.52 / 4.5 (5191 / 15368) 5.10 Heat pump nominal current A2/W35 in °C ( A36 / W95 in °F) / cos φ A / -- 6.8 / 0.99 5.11 Power consumption of heat pump fan...
-
Page 26: Dimension Drawing Heat Pump
English Air-/Water-Chiller-Heatpump 11 Dimension drawing 13. Dimension Drawing 11.1 Dimension drawing Monoblock 13.1 Dimension Drawing Heat Pump 452169.66.04 · FD 0007 www.glendimplex.de... -
Page 27: Dimension Drawing Hydrobox
465 LBS INCHES [MM] ANGLES ± 1° THIS DOCUMENT CONTAINS INFORMATION THAT IS CONFIDENTIAL AND PROPRIETARY TO TACO, INC. (“TACO”). IT IS PROVIDED FOR USE ONLY FOR THE PURPOSES EXPRESSLY STATED BY TACO. BY USING DATE SCALE SHEET 07/16/2020 SIZE... -
Page 28: Dimension Drawing Optional Domestic Hot Water Tank (Smt85-1)
13.4 Dimension Drawing Optional Domestic Hot Water Tank (SMT85-1) -
Page 29: Diagrams
14. Diagrams 14.1 Characteristic Curves Heating English Air-/Water-Chiller-Heatpump English Air-/Water-Chiller-Heatpump heating capacity [kW] heating capacity [BTU/h] 12 Diagrams 60,000 12 Diagrams 58,000 56,000 54,000 12.1 Characteristic Curves Heating 52,000 12.1 Characteristic Curves Heating 50,000 48,000 46,000 heating capacity 44,000 [kW] heating capacity [BTU/h] heating capacity... -
Page 30: Characteristic Curves Cooling
Air-/Water-Chiller-Heatpump English 14.2 Characteristic Curves Cooling 12.2 Characteristic Curves Cooling cooling capacity in [kW] cooling capacity [BTU/h] 58,000 56,000 Cooling capacity: 54,000 The min. and max. curve describes the range of the cooling capacity within the shown operating envelope 52,000 Volume flow 1,4 m³/h (6.16 gal/min) 50,000... -
Page 31: Information On The Use Of Data
IV. Information on Products and New Developments that your data is handled correctly. We should therefore like to provide you Taco and GDD will use your contact details on occasion to show you new with information on the data collected when operating the System M and products and innovations relating to smart homes. -
Page 32: Declaration Of Conformity
Consult the dealer or an experienced radio/TV technician for help. If in doubt as to whether a particular substance is suitable for use with a Taco This device complies with Industry Canada license exempt RSS product or part, or for any application restrictions, consult the applicable standard(s).
Need help?
Do you have a question about the Glen Dimplex System M and is the answer not in the manual?
Questions and answers