SAFERIGHT FALLRIGHT Megapod SA 17 User Instruction Manual

AS/NZS 5532:2013
Applicable to Megapod
Manufacturer
Certification Body &
Ongoing Assessment Body
CAREFULLY READ THESE INSTRUCTIONS BEFORE USING THIS MEGAPOD
This Megapod is designed to minimize the risk of/provide protection against the danger of falling from heights. However, always remember that no item of PPE can
provide full protection and care must always be taken while carrying out the risk related activity.
Note: The user is advised to keep the user information document for the life of product.
PERFORMANCE AND LIMITATIONS OF USE
The Megapod has been tested in accordance with AS/NZS 5532:2013 and has achieved the following performance levels :
test
AS/NZS 5532:2013
Static Strength
(Clause 5.3)
Dynamic Performance
(Clause 5.3)
link on your web browser -
LIMITATIONS :
1. Megapod should be a personal property of its user.
2. It should not be used in highly acidic or basic environments.
FITTING & SIZING :
The height of the Megapod (2 Mtr.)is adjustable from 1.30 m to 2.10 m & for
Megapod (3 Mtr.) from 1.90 m to 3.07 m depending on the conditions of
usage.
Step 1 : Place the Megapod on the floor with the feet on the ground.
Remove the locking Pins from the head and the legs.
Step 2 : Fully spread the legs and then replace the locking pins on head
to secure the legs in the open positions.
Step 3 : Resecure the locking pins int legs, after adjustment of the
required height or in fully extended position.
Step 4 : Place the Megapod over the entry point. Adjust the Megapod as
necessary by removing pins in one leg at a time. Adjust each
leg so the Megapod sits level above user's entry point. Ensure
that all pins are re installed.
Step 5: Caster Wheel mounted at the shoe of Megapod to provide
mobility. Caster wheel with locking system for stability while
usage.
Note :- Retrieval Block and Winch to be mounted simultaneously on the
legs of Mega pod and lifeline to be passed through pulley in
Head.
USER INSTRUCTION MANUAL
: SA 17
: 42 Belmont Avenue,Belmont WA 6104Ph: +61 8 9334 1000Fax: +61 8 9334 1001
: BSI Group ANZ Pty Limited, A.B.N. 72 078 659 211,
Suite 2, Level 7, 15 Talavera Road, Macquarie Park NSW 2113 Australia
"To be use in accordance with manufacturer instructions"
Sustained a force of 21kN for 3 minutes (PASS).
When tested with rigid steel mass of 150 kg, the test mass held after test with the
device remaining stable throughout. (PASS)
1
Result/Comment
SA 17 (2 Mtr.)
SA 17 (3 Mtr.)