Section 4. Winterizing - Polaris AutoClear PAGTF45 Installation And Operation Manual

TF Tablet Feeder | Installation & Operation Manual
Polaris AutoClear
® ™
Replacing Tablets
1. Turn control valve to the closed position. SHUT OFF PUMP.
2. Wait one minute allowing the water and fumes to drain from the feeder.
3. Leave the control valve closed. (The check valve will prevent water from
entering the feeder).
4. Rotate lid to open and access tablets. Refill with tablets.
5. Completely fill body with water, and bleed out entrapped air in all system
lines.
6. Press lid with o-ring seal firmly into body. O-ring should be clean, lubricated
with silicone based lubricant and in place. Engage cover threads and turn
clockwise to seal. (Hand tighten only).
7. Open control valve to original setting. Inspect the inlet line below the control
valve for leaks each time the feeder is refilled. Replace the lines yearly if
needed.
NOTE: Keep an eye on the tablet level in the unit, preferably reload BEFORE
they run out.

Section 4. Winterizing

NOTE: If the equipment is subject to freezing conditions, it will be necessary to
winterize the unit following these instructions.
1. Ensure that all power to the equipment system is disconnected/ turned off.
2. Drain water from the unit by disconnecting one side of the hose or pipe
connections.
3. Remove any remnants of undissolved chemical tablets, rinse out the body
with clean water.
4. Follow other normal procedures for your system to winterize.
5. Consult manufacturer instructions for winterizing additional equipment.
ENGLISH
Page 9