Advertisement
Table of Contents
- 1 Required Equipment
- 2 Update Instructions
- 3 Step 1: Unzip & Extract the Provided Folder
- 4 Step 2: Plug the USB-C Data Cable into Your Wireless Controller
- 5 Step 3: Run the Update Firmware Software
- 6 Step 4: Follow the Prompts to Complete the Upgrade
- 7 Step 5: Reset the Controller and Follow Synchronization Guide
- 8 NOTE: if You Experience any Problems, Please E-Mail Support
- Download this manual
SG60043-44 Firmware Update Instructions
Required Equipment
Computer
•
•
USB - USB-C data transfer cable (cable included with device is compatible)
SwitchPad Pro Controller
•
•
Firmware Update File
Update Instructions
Step 1
Unzip & extract the provided folder
Step 2
Plug the USB-C data cable into your wireless controller. Press and hold the L3 Button
(click left stick in) and connect the USB cable to the computers USB port, release L3 after
connecting to computer.
Advertisement
Table of Contents
Summary of Contents for SURGE SG60043-44
- Page 1 SG60043-44 Firmware Update Instructions Required Equipment Computer • • USB - USB-C data transfer cable (cable included with device is compatible) SwitchPad Pro Controller • • Firmware Update File Update Instructions Step 1 Unzip & extract the provided folder Step 2 Plug the USB-C data cable into your wireless controller.
- Page 2 SG60043-44 Firmware Update Instructions Step 3 Run the update firmware software by double clicking the file “SG60043-44-FirmwareUpdate- 07-13-2021 Step 4 Follow the prompts, click “OK” to complete the upgrade Step 5 After the update is complete, reset the controller via the button on the back and follow the...
Need help?
Do you have a question about the SG60043-44 and is the answer not in the manual?
Questions and answers