HTC One V Basic Manual page 30

30 Basics Guide
ƒ
Damage requiring service
Unplug the product from the electrical outlet and refer servicing to an authorized service
technician or provider under the following conditions:
•
Liquid has been spilled or an object has fallen into the product.
•
The product has been exposed to rain or water.
•
The product has been dropped or damaged.
•
There are noticeable signs of overheating.
•
The product does not operate normally when you follow the operating instructions.
ƒ
Avoid hot areas
The product should be placed away from heat sources such as radiators, heat registers,
stoves, or other products (including amplifiers) that produce heat.
ƒ
Avoid wet areas
Never use the product in rain, or near washbasins or other wet locations. If your product
gets wet, do not try to dry the product with the use of an oven or dryer, as this may
damage your product.
ƒ
Avoid using your device after a dramatic change in temperature
When you move your device between environments with very different temperature and/
or humidity ranges, condensation may form on or within the device. To avoid damaging
the device, allow sufficient time for the moisture to evaporate before using the device.
NOTICE: When taking the device from low-temperature conditions into a warmer
environment or from high-temperature conditions into a cooler environment,
allow the device to acclimate to room temperature before turning on power.
ƒ
Avoid pushing objects into product
Never push objects of any kind into cabinet slots or other openings in the product.
Slots and openings are provided for ventilation. These openings must not be blocked or
covered.
ƒ
Air bags
Do not place a phone in the area over an air bag or in the air bag deployment area. Store
the phone safely before driving your vehicle.
ƒ
Mounting accessories
Do not use the product on an unstable table, cart, stand, tripod, or bracket. Any
mounting of the product should follow the manufacturer's instructions, and should use a
mounting accessory recommended by the manufacturer.
ƒ
Avoid unstable mounting
Do not place the product with an unstable base.