Advertisement
ITEM
028-00693 (EDG-177)
An airspeed sensor with four user-defined ranges (from 250 FPM to 2000 FPM / 1.25 MPS to 10 MPS) is
now available. It provides a 4-20 mA output proportional to the air velocity. The sensor may be located
any distance from the EDGE
600 ohms. It can measure ambient temperature ranges from 32°F
to 140°F (0°C to 60°C). The probe should be located where
conditions are representative of the overall environment being
monitored, and connected to a conduit (or other means) with a ½"
NPT connection.
Sensor is not orientation sensitive.
Sensor is intended for use with dry air.
Requires EDGE
TM
software version 2.5 or higher to log, monitor,
and alarm at user-defined levels.
No logic is related to ventilation compensation.
Do not power this sensor from an EDGE
more current than card can provide.
For sensor set-up instructions, continue to the next page.
Copyright© 2019 AGCO Corporation •
Airspeed Sensor
HOT-WIRE AIR VELOCITY TRANSMITTER, 4-20mA OUTPUT
TM
expansion box provided that the total loop resistance does not exceed
TM
card as it requires
www.cumberlandpoultry.com
DESCRIPTION
•
www.automatedproduction.com
LBS KGS
1.1
0.5
1
Advertisement
Table of Contents
Related Manuals for Cumberland EDG-177
Summary of Contents for Cumberland EDG-177
- Page 1 ITEM DESCRIPTION LBS KGS 028-00693 (EDG-177) HOT-WIRE AIR VELOCITY TRANSMITTER, 4-20mA OUTPUT An airspeed sensor with four user-defined ranges (from 250 FPM to 2000 FPM / 1.25 MPS to 10 MPS) is now available. It provides a 4-20 mA output proportional to the air velocity. The sensor may be located...
- Page 2 SENSOR SETUP To complete these steps the sensor must have power. 1. Remove the sensor cover; press “SELECT” button until “RANGE” indicator LED is illuminated. 2. Press “ENTER” 3. Turn the “ADJUST” knob until the desired range indication is achieved. The “RUN”, FILTER”, “A”, “B”, and “C”...
- Page 3 To restore to the factory default settings, start with the unit in the “RUN” mode. Press and hold the “ENTER” button. The “RUN” LED indicator will begin to blink. After about 2.5 seconds all LED indicators will flash indicating the factory settings have been restored. Range settings are not affected by this operation.
- Page 4 CONFIGURING EDGE SOFTWARE ALARMS FOR AIRSPEED SENSOR: 1. Select the Setup Icon. 2. Select the room to which the alarm will be added. 3. At the bottom of the page, select the Alarm button. 4. Select Generic Input. 5. Select the sensor you want to add the alarm to. 6.
Need help?
Do you have a question about the EDG-177 and is the answer not in the manual?
Questions and answers