Page 1
The SenseAir portable sensor is a lightweight CO instrument with a digital display designed to measure the carbon dioxide concentration in ambient air. Built-in data logging and alarm functions with both audible alarm and LEDs make this portable pocket size instrument perfect for personal safety applications.
LED is lit and an intermitted audio alarm is triggered. If the concentration continues to rise the red LED is lit as the second alarm level is reached and a continuous audio alarm is triggered.
Page 3
8-16 seconds. Application function for "standard" default setting is just backlight. Acknowledge Alarm In alarm and pre alarm states, pushing the button resets the sounding buzzer for 5 minutes at a time. EM_SenseAir_Alarm_RTC_Oct'05 Page 3 of 12...
Page 4
The backlight is automatically turned on at pre and main alarm and turned off 8-16 seconds after alarm acknowledgement. If the alarm condition remains 5 minutes from alarm acknowledgement the buzzer becomes actuated again. When the alarm condition has vanished the SenseAir Alarm returns to normal operation with the buzzer silenced (- if not acknowledged the backlight will remain on).
The SenseAir is basically maintenance free. The system contains a complete self-diagnostic routine, which is executed automatically every time the power is turned on. The unit will then perform a full self-test sequence showing the LEDs and buzzer response for the alarm setpoints SenseAir is working with continuous self-diagnostics during operation (On Mode).
Page 6
Software Program UIP-P is a PC software tool that can be free downloaded from http://www.senseair.com/. Together with the included cable the SenseAir can be connected to a computer to: Load measured samples from SenseAir Alarm into the computer. Configure the trigger levels for the five LEDs.
Page 7
Send the new settings to the sensor by pushing the button Send to sensor. In the folder Buzzer the alarm limits are set. Figure 6. The folder Display in UIP-P shows what Figure 7.In the folder Buzzer in UIP-P the alarm Is shown on the display.
Page 8
Figure 9. In the folder Logger in UIP-P the sampled readings are shown in real time. Sampling CO readings SenseAir Alarm continuously samples CO readings. The internal sample counter is active in On mode and is reset if the sensor is turned off without the charger connected. All readings sampled when the counter was active can be seen in User Interface Program UIP-P.
Page 9
Tips before a measurement • If possibly do the measurements without the charger connected. • Start the measurement with a fully charged battery. • Select a sampling interval without overwriting samples. Note! • If the sensor is turned off without the charger connected the sample counter is cleared.
On Mode. Also, the display options will be enhanced and include the result of this extra function. These files are free and are included in the UIP_P software package, which can be downloaded from SenseAir's web site www.senseair.com. You are welcome to suggest new...
Page 11
* battery status indication * sensor status indication Audible horn ..............Transducer with 2kHz resonance frequency, sounding during alarm status until push-button acknowledgement is pressed Push-button ................ a single multi-purpose push-button Internal Data Logger with RTC......... The latest 8 hours’ TWA (T...
Page 12
WARRANTY AND LIMITATION OF LIABILITY 1. SenseAir warrants that for a period of twelve (12) months following receipt by Buyer the Product supplied by SenseAir to Buyer will be, under normal use and care, free from defects in workmanship or material and to be in material conformity with SenseAir's specifications.