Advertisement
Quick Links
Installation Instructions
AHD-3
11-7/8"
Drill hole
02
Electrical box location
1. Use the template provided inside of the box.
2. Use a level to insure that the template is straight and
level, the electrical box must be a 7/8" from the edge
of template to the edge of the box.
3. Use painters tape to hold the template in place.
4. Drill holes for supplied plastic anchors.
AHD-5
12-1/4"
7/8"
Shell
5. Place the
plastic anchors in
the holes and
push them with
the help of a lite
hammer.
User Manual
Model: AHD-3 & Model: AHD-5
Specifications
Stainless Steel Front Cover
110 - 120V
11.7 Amps
550 - 1200W
Hardwire Connection
HEPA Filter
All hardware necessary for satisfactory installation
Tools Needed
Safety Glasses
Hammer
Phillips Screw Driver
Recommended Mounting Heights
01
6-3/4"
Floor
Shell remove
03
Automatic Hand Dryer
Level
Cordless Drill
Drill bit
Ø 1/4" Carbide
Drill for tile
Tape
From Floor to bottom of Hand Dryer
Men
45"
(114cm)
Women
43"
(109cm)
Teenagers
42"
(107cm)
Small childrens 34"
(86cm)
Handicapped
38"
(97cm)
Countersunk
screws
Allen wrench
Use Allen wrench from
accessories bag to remove
2 countersunk screws from
body shell.
Pull the shell upward by
hands to remove.
Please avoid damage to
shell finish.
PAGE | 01
Advertisement
Summary of Contents for Mac Faucets AHD-3
- Page 1 User Manual Automatic Hand Dryer Installation Instructions Model: AHD-3 & Model: AHD-5 Specifications Stainless Steel Front Cover 110 - 120V 11.7 Amps 550 - 1200W Hardwire Connection HEPA Filter All hardware necessary for satisfactory installation AHD-3 AHD-5 Tools Needed 11-7/8”...
- Page 2 Mounting instructions Connect the hand Dryer All wire connections MUST BE conducted by an experienced electrical contractor. Connect to an independent 20 Amp circuit braker. Electrical Box Install Electrical Box inside Grounding device the wall. Location is shown in 02 page 1, point 2 Electrical Box must be Hand dryers MUST BE flush with the wall surface.