IMPORTANT
SAFEGUARDS
Read these instructions carefully and
retain them for future use. If this product
is passed to a third party, then these
instructions must be included.
When using the product, basic safety precautions
should always be followed to reduce the risk of
injury including the following:
•
Do not use the product to loosen bolts, screws
or the like, as this might damage the ratchet
and the calibrated settings.
•
Do not use brute force on the product to
tighten a nut/screw. During tightening apply a
steady and consistent pressure. Do not use as a
nut breaker, pry bar, hammer, or lever bar.
•
To prevent damage to the product, stop
applying pressure when the "click" sound is
heard. Bear in mind that the "click" sound is
acoustically weaker with lower torque settings.
•
The product should be re-calibrated when it has
been subjected to an overload greater than its
rated capacity, after repair, or after any improper
handling which might influence the errors of
measurement.
EN
3