AEG S71700TSW0 User Manual page 12

12 www.aeg.com
8.4 Installing under a
continuous worktop
If your refrigerator is installed under a
continuous worktop, an air outlet
opening of at least 200cm
ventilation grille matching the worktop
design should be installed at the rear of
the worktop.
The cut surfaces of the worktop should
be varnished to avoid swelling due to
penetration of moisture.
The appliance wall distance must be at
least 30 mm and should be checked
before the ventilation grille is inserted.
200 cm
93-103 mm
8.5 Detaching the worktop
1. Unscrew the left and the right screws
at the back.
100 mm
15 mm
2
and a
A
2
105 mm
570 mm
550 mm
min. 820 mm
500/550/600 mm
2
15 mm
2. Push the worktop backwards and lift
it up.
Store the screws in a safe place together
with the worktop.
8.6 Fitting and mounting to
continuous worktop
Before fitting, change the door opening
direction if necessary (see: Door
reversibility).
1. Push the appliance carefully into the
niche.
Take care that the mains cable is not
jammed in.
2. Check distance from wall (see:
Installing under a continuous
worktop).
3. Level the appliance by screwing the
two adjustable feet at the front in or
out, thus ensuring a stable position.
4. With a suitable screws (depending on
the design of the worktop and the
distance between the appliance and
the worktop, not supplied), fix the
appliance under the worktop through
the upper door hinge.
1
3