Advertisement
Quick Links
KNX LINE COUPLER
LC-S.1
BASIC INFORMATION
The KNX line coupler provides a bi-directional data connection between two KNX TP lines or areas and works as
a KNX network. KNX TP main line and KNX TP subline are coupled having a galvanic isolation in between.
• Various routing filter for group and individual telegrams
• Temporary disabling of routing filter via button
• Long telegrams with up to 240 bytes APDU length are supported
• LED status indication
• Galvanic isolation of connected lines
• Integrated ACK generator
• Power supply via KNX bus
• Low power consumption
• DIN rail 35mm mounting
A. Function button
1. LED bus state KNX TP (main line) 2. LED bus state KNX TP (subline) 3. LED telegram traffic KNX TP (main line)
4. LED telegram traffic KNX TP (subline) 5. LED group address routing 6. LED physical address routing
1
3
5
7
B. Programming button C. KNX TP main line connector D. KNX TP subline connector
7. Programming LED
Module Electronic LLC
module-electronic.ru, info@module-electronic.ru
phone: +7-495-150-27-25
page 1
2
4
6
A
B
D
C
PASSPORT
МГРЛ-27.12.1931-007.01 ПС
Advertisement
Summary of Contents for Module Electronic KNX LC-S.1
- Page 1 1. LED bus state KNX TP (main line) 2. LED bus state KNX TP (subline) 3. LED telegram traffic KNX TP (main line) 4. LED telegram traffic KNX TP (subline) 5. LED group address routing 6. LED physical address routing 7. Programming LED Module Electronic LLC module-electronic.ru, info@module-electronic.ru phone: +7-495-150-27-25...
- Page 2 page 2 SPECIFICATIONS Device model LC-S.1 KNX interfaces (Main, Sub) Specification TP-256 Available application so ware ETS 4 and later 4-wire EIB connector (PUSH WIRE spring clips) for standard KNX connector cable TP1 0,8мм Ø KNX physical address by default 15.15.0 Power supply via KNX bus: 21...30В...
- Page 3 PASSPORT LC-S.1 МГРЛ-27.12.1931-007.01 ПС page 3 INSTALLATION Attaching to DIN rail Removing from DIN rail WIRING DIAGRAMS MAIN KNX bus (Main) KNX bus (Sub)
- Page 4 page 4 SAFETY INSTRUCTIONS ATTENTION! Installation and connection of the device to the mains must only be carried out by qualified personnel! Be sure to turn off the power before installing or removing the device! The design of the device meets the requirements of electrical safety according to GOST 12.2.007.0-75. SETTING INSTRUCTIONS The device is set up in accordance with the instruction manual.
Need help?
Do you have a question about the KNX LC-S.1 and is the answer not in the manual?
Questions and answers