Table of Contents
Advertisement
FALCOM A2
-
Pull the BRSF pin to ground.
-
Start the flashburner.exe. Don' t change the MIPS Loader File
Path and the MIPS Executable File Path!
-
Select the serial port the modem is connected to and hit the
START DOWNLOAD button. If the power supply was
disconnected, reconnect it.
-
Pull the SOFT ON pin to HIGH until the LOADER PROGRAM
LOADING bar is filled (approx. 7 sec).
-
Release the SOFT ON. The program continues with ERASING
FLASH and BURNING FLASH.
-
Wait until update process is finished (this takes approx. 2 min 14
sec, then all bars are filled blue and the buttons are changing from
grey to black).
-
Hit EXIT.
-
Disconnect BRSF from ground.
-
Reset the module by using RSTF or disconnect the power supply.
The new software version is now implemented. It should be investigated by
using the AT+CGMR command.
This confidential document is the property of Funkanlagen Leipoldt OHG and may not be copied or circulated without permission.
A2MAN.DOC
08 MARCH 1999
Page 52
Advertisement
Table of Contents
