Morphy Richards Meno One Cup Instructions Manual page 7

KT43923MEE Rev2 - MenoOneCup:9225 47507 MEE pump - Jon
Problem
The start button will not work.
My Meno One Cup does not dispense a
full cup.
My cup is overfilling.
My Meno One Cup makes an unusual
noise once boiled.
The temperature of the water seems
cooler.
My Meno One Cup does not boil or
illuminate.
Occasionally, water drips from the spout
after the unit has dispensed hot water.
There is steam coming through the top
of my Meno One Cup.
Reason
The Meno One Cup needs to reset after
its last use.
1. The cup size selector is not set
correctly.
2. There is less than one cup's volume in
the water reservoir.
The cup size selector is not set correctly.
This is the dispense mechanism resetting
so that only one cup is dispensed at a
time.
There may be a build up of limescale.
1. Your Meno One Cup is not plugged in.
2. The base unit is not attached to the
unit.
3. There is no water in the water
reservoir.
There may be a small amount of residual
water left in the pump after it has been
dispensed.
As with a standard kettle, boiling water
will produce steam which needs to be
released.
15/2/10 17:02 Page 7
Solution
Wait for five seconds and try again.
1. Adjust the cup size selector according
to the cup you have placed on the drip
tray.
2. Refill your Meno One Cup.
Adjust the cup size selector according to
the cup you have placed on the drip tray.
This means it is working correctly.
Descale your Meno One Cup
(refer to Descaling.)
1. Plug it in and switch on at the socket.
2. Check the base and unit are connected
correctly.
3. Once your Meno One Cup has cooled
down, refill with cold water.
This is normal. The drip tray will catch
any drops that may occur.
This is normal, your Meno One Cup has
been designed to direct steam in this
way.
g
7