Advertisement
4. Setting the ID
Refer to this section of your the remote is not working or you are
experiencing interference from another remote:
1.) Push the M-key and Composite Switch
Push key simultaneously at least 5
seconds (A Green LED light will flash)
(Change a new ID).
2.) Use a pen to push the receiver's button, but
do not remove from the USB port to do so.
You will feel the button click when it is
pressed.
3.) Push any button except the laser key or M-
Key to send a new ID to the receiver
4.) You should now have full control of the mouse. If not, please try step 1-3
again. Please note that every time you take the battery out, the mouse ID
will be reset. If your mouse doesn't work then you have to do the steps 1 to 3
to set up a new ID again.
You have 40 seconds when setting the receiver ID.
Advertisement
