NAL CabiLIFT Instructions

WARNINGS
Failure to observe these WARNINGS could damage the hand cups or the load
or cause injury to the user.
The CabiLIFT is totally unsuitable and unsafe for attachment to
hoists, manipulators, fork-lifts or for use with any other lifting method or
device.
Do not use the cups to lift loads that exceed the maximum load capacity
or the effective capacity.
Do not lift load if you do not feel comfortable with the weight you are
attempting to lift.
Do not use the cups to support a person.
Do not place the cups face against surfaces which could damage the
sealing edges.
Avoid conditions that could cause the cups to slip or disengage
prematurely, such as contaminants, cuts or scratches in the cups face, or
contact surface. Applying the cups to porous materials or applying
pressure against the cups edge.
Do not use the cups to lift when the red line is visible. If the red line
reappears frequently, discontinue use and see service.
Do not allow anything to interfere with free movement of the plunger
while the cups are attached.
Do not touch the release valve levers while lifting.
Do not use harsh chemicals, (such as solvents or gasoline or unauthorised
rubber cleaners and conditioners to clean the cups).
Tel: +44 (0)1905 427100
E-mail: sales@nal.ltd.uk
www.nal.ltd.uk
NAL Ltd
Weir Lane, Worcester, WR2 4AY
Fax: +44 (0)1905 427030
www.nal.ltd.uk
IMPORTANT READ THIS
INSTRUCTIONS FOR CabiLIFT CABINET LIFTERS
Handle locking bolts
Horizontal removable carrying handles
OPERATION
To attach
1 Position the lifter on to the load ensuring vacuum cups are in contact with
surface so that the red line can be visible.
2 Apply pressure and pump the plungers until the cups attach completely. When
the red line is hidden, vacuum is sufficient for lifting.
3 Check the plunger frequently to make sure the cups remain securely attached. If
the red line appears while lifting, set down the load immediately and pump the
plunger until the red line is hidden again, (see WARNINGS).
4 When using the CabiLIFT in the vertical position the long handled carrying
handles can be removed by removing the 2 locking bolts.
To Release
1 Set the load on a secure support/base.
2 Press the release valve until the cup disengages.
CAUTION: Remove the cups when not in use.
Cleaning
1 Remove the air lifter from the cups surface.
2 Use a clean sponge or lint free cloth to apply soapy water or other mild cleanser
to the cups face. See WARNINGS for more information.
CAUTION: To prevent liquid from contaminating the pump, hold the cup face
facing down or cover the suction hole in the filter recess.
3 Wipe all residue from the cup faces.
4 Allow the cup to dry and re-install the air lifter.
For further advice Tel: 01905 427100
www.nal.ltd.uk
Vertical lifting handle
Plunger with red line indicator
Vacuum release valve
Vacuum cups