Subscribe to Our Youtube Channel
Summary of Contents for Aussie PRO SKI
- Page 1 AUSSIE PRO SKI Owners Manual Read all instructions carefully before using this product. Retain this owner’s manual for future reference AUSSIE F I T N E S S P R O S...
-
Page 2: Important Safety Instructions
WARNING - FOR YOUR SAFETY AND BENEFIT Read the entire AUSSIE PRO SKI Operating Instruction manual before use. To prolong the life of your AUSSIE PRO SKI it is important that you provide regular maintenance. Failing to do so will void your warranty. - Page 3 -Pregnant or breastfeeding -Stop exercising immediately and consult your doctor if you feel dizzy, have heart pain or any other illness. -Drink water when exercising longer than 20 minutes AUSSIE F I T N E S S P R O S...
- Page 4 ASSEMBLY Carefully cut the straps and open all sides of the Box Remove the content making sure not to miss a piece Lay out all the parts. You will find two sets of allen keys tied to the top of the column. You can remove them and carefully set the metal cross bar on the column.
- Page 5 ASSEMBLY stand the column over the platform and use the four large bolts to fasten the column to the platform. Make sure each bolt is in hand tight before tightening all the way Take this 45 degree plate and fasten it to the rear of the machine with the 4 small bolts.
- Page 6 ASSEMBLY Install the pipe cross bracing. You will attach with the rear pipe bracket and the 4 small screws. make sure all bolts are in and hand tightened before fully tightening. Make sure the pipe cross bracing is centered, then fasten the bottom of the cross bracing with a large bolt on each side.
- Page 7 ASSEMBLY Next take the 4 small bolts and attach the right arm. Set it into place and attach one bolt followed by the next. Repeat for the left arm. Make sure all bolts are fully tightened...
- Page 8 ASSEMBLY attach the cross bar at the top. You will fasten by bolting from the outside of the arm going in. This is much easier with a mate.
- Page 9 ASSEMBLY tip the machine down and secure the 45 degree plate you installed earlier with 2 large bolts. Be sure to check all bolts and make sure they are properly tightened.
- Page 10 ASSEMBLY Your Aussie Pro Ski is complete...
Need help?
Do you have a question about the PRO SKI and is the answer not in the manual?
Questions and answers