Download Print this page

Greenote GSC50 Troubleshooting Manual

Hide thumbs Also See for GSC50:

Troubleshooting Guide for Greenote GSC50

1）My vacuum has low suction or no suction at all？

If the suction power of your hoover has decreased significantly after a

period of use. This may be caused by a blockage inside the machine that

has not been cleaned for a long time.

Turn vacuum off and remove floor nozzle from wand. Remove soft roller

using eject tab on left side of nozzle.

Check where hair tangled :

1. Check your floor brush head

2. Check your brush room

3. Check your brush connections

4. Checking the connection of telescopic tube

Solution:

Try using a long hook or chopstick to dig out any blockages that have

become entangled in the machine, or tap down to guide the blockage

out.

Table of Contents

Need help?

Do you have a question about the GSC50 and is the answer not in the manual?

Page 1 Troubleshooting Guide for Greenote GSC50 1）My vacuum has low suction or no suction at all？ If the suction power of your hoover has decreased significantly after a period of use. This may be caused by a blockage inside the machine that has not been cleaned for a long time.
Page 2 2）My vacuum has shorter run time than expected？ To get the most run time, ensure that the battery is fully charged before use. If all 3 battery LEDs are solidly illuminated when on the battery, the battery is fully charged. Note: The unit can take up to 4 hours to fully charge.
Page 3 4）My Vacuum is noisier than expected？ Note: The lower power modes (ex: Bare Floor ECO or Deep Clean) are significantly less noisy. Power mode specifically is noisy due to the high power. Remove the handheld vacuum from the wand. Turn on the Handheld. 5）Why does my vacuum cleaner suddenly fail to turn on? Please ensure the stable connection between battery and dust cup with motor （in order from bottom to top to connect）, try to pull battery gently to test if the...