Table of Contents
Advertisement
this feature, along with your speaker manufacturer's recommended crossover
frequencies, to quickly design a more advanced system
•
and 24dB per octave slope. The steep crossover slope keeps midrange tones out
of the subwoofer and thereby eliminates an unnatural "nasal" tone quality in
the audio system.
•
and fullrange. If lowpass is selected, the lowpass filter controls will control
the crossover frequency.
•
input allows full left and right stereo operation. Right (bridged) input allows
single channel input for bridged operation. This is especially useful in high-
powered systems when using one amplifier for each subwoofer/speaker. L + R
(sum mono) allows a stereo input to be summed into a mono output.
•
source. In addition, these connections are provided for installations where the
source unit's RCA outputs are unavailable.
When using the speaker (high-level) inputs, the Black wire must
be grounded at the Radio. Failure to do this will result in noise and improper
operation.
CONNECTIONS FOR POWER AND SPEAKERS
The rear panel of the DPX1000.2 contains power and speaker connections as
shown below.
1 Left Speaker Output
2 Right Speaker Output
3 Ground Input
- This switch will change the X-Over between a 12db
- This switch is to change the output between lowpass
- This switch allows you to set the input mode. Stereo
- These provide connections for a high-level stereo
1
2
OWNER'S MANUAL
3
4
5
4 Remote Turn-on Input
5 Battery + 12v Input
5
Advertisement
Table of Contents
