Taunotent TONNEAU COVER Fitment Instructions

FITMENT INSTRUCTIONS
TONNEAU COVER
Tool requirement for fitment:
Size 10 spanner or socket
4 bolts with washers
Place front rail over the holes located on the front edge of the loadbin and using bolts fasten in place. If there is rub-
berising, use the rail as a marker to locate the holes. Using a blade, gently scrape the rubberising away to locate the
holes and then fit the rail.
Attach the two long side rails on either side of the loadbin using clamps to fasten into place.
Attach the two short side rails on either side of the load-
bin towards the back using one clamp per rail to fasten.
Insert support braces into brace holders using the
stickers as reference.
This fitment instruction applies to:
FORD FX4 WITH ROLLBAR
Tonneau kit comprises: 1 x clip on tonneau cover, 1x front aluminium
rail, 2 x long side rails with 2 clamps per rail, 2 x short side rails with 1
clamp per rail, 2 x back corners, 2 x support braces, 4 x brace holders,
4 x end caps.
Clip on Tonneau cover fitment
instructions for Ford FX4 fitted
Insert the tailgate into the 2 small side rails using the
plastic corners. Tighten the screws on the corners.
on edge of loadbin