Table of Contents
Advertisement
16
www.aeg.com
Problem
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC" or "COOLMATIC", or af-
ter changing the tempera-
ture.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
This is normal, no error has
occurred.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "FROSTMATIC func-
tion" or "COOLMATIC
function" is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "FROSTMATIC func-
tion" or "COOLMATIC
function" is switched on.
Solution
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "FROSTMATIC
function" or "COOLMATIC
function" manually, or wait un-
til the function resets automat-
ically to set the temperature.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
Advertisement
Table of Contents
