jWIN JG-MRS42 Owner's Manual

General mobile radio service (gmrs)

Advertisement

jWIN
®
General Mobile Radio Service (GMRS)
Model: JG-MRS42
Owner's Manual
Printed in Korea
Part No. PT36-041-011

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JG-MRS42 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for jWIN JG-MRS42

  • Page 1 ® General Mobile Radio Service (GMRS) Model: JG-MRS42 Owner’s Manual Printed in Korea Part No. PT36-041-011...
  • Page 2: Table Of Contents

    1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
  • Page 3: Introduction

    Belt clip (attached) This manual Please check for these items carefully. If any items are missing, please call jWIN Electronics Corp Customer support at 1-866-807-JWIN between 9am and 5pm EST (Eastern Standard Time). jWIN GMRS radio has following features. Two-way radio with up to a 5 mile range...
  • Page 4: Operation

    Antenna Belt clip Speaker/Microphone/Charger jack Power/Volume knob Backlit LCD Menu/Scan Call/EMG (Emergency) Scroll key Microphone (10) Battery cover latch (11) Charging pads (12) Battery cover (13) Speaker (14) Power Hi/Low (15) Monitor/Lamp (16) Push-to-talk (17) Transmission/Reception (TX/RX) LED This device complies with Part 15 of the FCC rules, Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including...
  • Page 5: Belt Clip Installation

    The radio is continuously in receiving mode when powered on. Incoming signal can be heard only when both (transmitter & receiver) radios are on the same channel & CTCSS. The RX LED will light up in amber when incoming signal is encoded with CTCSS.
  • Page 6: Transmitting A Call Tone

    Transmitting a Call Tone Press and hold Call/EMG button till the TX LED lights up in red, and the LCD displays CALL. Then release Call/EMG button. This GMRS radio has 5 different Call Tones. Please refer to Menu chapter to set different Call Tone. EMG (Emergency) Press and release Call/EMG button when you are in an emergency situation.
  • Page 7: Monitor

    Monitor This feature turns off the Automatic Squelch feature momentarily. This allows your unit to receive all signals to its maximum range, but it may pick up static signals as well. You can set the speaker volume by the noise of the static. To activate this, press the Monitor button for up to 0.5 seconds.
  • Page 8: Menu - Option Settings Chart

    Menu – Option settings chart LCD prompt Option setting CTCSS Key stroke on/off Key pad lock Roger beep VOX activation Time out Timer Call Tone melody Frequency table A. Frequency & channel assignment Key operation CH 1: Menu CH 2: up/down (select) CH 3: push-to-talk (quit)
  • Page 9: Trouble Shooting

    Interference from electronic devices such as computers or TV Customer Support Thank you for purchasing the jWIN GMRS 2-way Radio. This is a high- Correction quality communications device that can give you many years of reliable Charge or replace service. Please read these instructions carefully.
  • Page 10 The Warranty is " Not " transferable. jWIN agrees, that within the initial "90 Day " period to repair the product if it is determined to be defective at " No Charge ". It is further agreed that jWIN will cover the cost to repair or replace damaged " PARTS "...

Table of Contents